1998 XJ
12-13-2020 | 05:34 PM
#1
Thread Starter
Newbie
Joined: Dec 2020
Posts: 1
Likes: 0
From: Boise Idaho
Year: 1998
Model: Cherokee (XJ)
Engine: 4.0
1998 XJ
Engine started to run rough and revving and stalled. Set code P0121 throttle pedal position sensor A circuit range performance. Simple, tested wiring ground, 5 volt reference and output to PCM. What I found is i have 4.96VDC on my signal wire, with sensor pluged in and when unplugged. Unplugged PCM and tested pin A23 and have 6.4VDC. Signal wire no shorted to any wiring to PCM or ground or battery positive. Any advice would be helpful.
12-13-2020 | 08:22 PM
#2
CF Veteran
Joined: May 2012
Posts: 7,964
Likes: 957
From: Lost in the wilds of Virginia
Year: 1998 Classic (I'll get it running soon....) and 02 Grand
Model: Cherokee (XJ)
Engine: 4.0
Welcome!
That's not a complete test of the TPS. You need to test the output as you sweep the TPS across the range of motion. There are a bunch of good videos on the Tube.
That's not a complete test of the TPS. You need to test the output as you sweep the TPS across the range of motion. There are a bunch of good videos on the Tube.
Thread
Thread Starter
Forum
Replies
Last Post
alpine.adrenaline
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
08-20-2019 12:00 PM
Rockie
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
08-07-2017 03:40 PM
gregspappy
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
05-04-2014 12:08 PM
hondotexas
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
02-18-2013 09:17 PM
Oldbluexj
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
08-09-2011 12:02 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)