88 Cherokee Random Rough Running

Reply Subscribe

Thread Tools

Search this Thread

10-23-2012, 07:02 AM

#16

cruiser54

::CF Moderator::

Join Date: Aug 2011

Location: Prescott, Az

Posts: 43,971

Likes: 1,979

Received 1,559 Likes on 1,263 Posts

Year: 1990

Model: Cherokee (XJ)

Engine: 4.0

Quote:

Originally Posted by je4reyk

Also check your wiring harness and the plug (c101) bulkhead connector ,my 88 was having issues . It turned out that the bulkhead connector was causing all sorts of problems,finely had to deleate the connector ,made a bid difference.

Renix Jeep C101 Connector Refreshing
　
The C101 connector on 1987 and 1988 Renix Jeeps was a source of electrical resistance when the vehicles were new. So much so that the factory eliminated this connector in the 1989 and 1990 models. The factory recommended cleaning this connector to insure the proper voltage and ground signals between the ECU and the fuel injection sensors. We can only imagine how this connector has become a larger source of voltage loss and increased resistance over a period of almost 25 years. The C101 connector needs to be cleaned at least once in the lifetime of your vehicle. Chances are it’s never been done before.

Almost every critical signal between the engine sensors, injectors, ECU, and some to the TCU, travel this path through the C101 connector.
The C101 connector is located on the driver’s side firewall above and behind the brake booster. It is held together with a single bolt in it’s center. To get the connectors apart, simply remove the bolt and pull the halves apart. You will find the connector is packed with a black tar like substance which has hardened over time.
Take a pocket screwdriver or the like and scrape out all the tar crap you can. Follow up by spraying out both connector halves with brake cleaner and then swabbing out the remainder of the tar. Repeat this procedure until the tar is totally removed. This may require 3 or more repetitions. Wipe out the connectors after spraying with a soft cloth.
If you have a small pick or dental tool, tweak the female connectors on the one side so they grab the pins on the opposite side a bit tighter before bolting both halves back together.
　
Revised 07-17-2012