90 renix 4.0 stalls/low idle
#1
Newbie
Thread Starter
Join Date: Nov 2008
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
90 renix 4.0 stalls/low idle
so i've had this cherokee for about a year on the road now i've constantly had this problem. On long drives coming to a stop I'll push in the clutch and it stalls right out. Starts back up and revs normal down back to idle. I've changed my tps iac map sensor and coolant sensor checked for vacuum leaks changed plugs wires cap rotor coil and I've gone through the entire fuel system. All my injectors pass resistance tests (I actually changed them over to 5.0 ford injectors) good fuel pressure and volume. I've also tried catching the problem diagnosis tools to no avail all the voltages are right. I'm beginning to think I have egr issues due to the fact that every electrical route I've taken has been a dead end. Anyone else have an opinion or a test route I haven't taken?
#3
Mine did that when the vacuum line to the MAP cracked. Check the line to make sure it's not cracked and also make sure there is vacuum on the line, that's it's not blocked somewhere. If everything seems normal disconnect the vacuum line to the MAP and drive it. If it does not get worse your MAP is not working, or the wiring is messed up.
#6
Newbie
Thread Starter
Join Date: Nov 2008
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
they're 19lb/hr a whopping improvement from the 18.6 they literally make no difference it's not flooding or running rich and it dies almost immediately when i disconnect the map sensor
#7
CF Veteran
Join Date: Jun 2009
Posts: 5,383
Likes: 0
Received 5 Likes
on
1 Post
Year: 1988 limited
Model: Cherokee
Engine: 4.0 litre
Why would you disconnect the map sensor?
I suggest you build the small circuit to adjust the 5v signal of the MAP sensor so you can calibrate the fuel delivery.
http://www.angelfire.com/my/fan/MAP_adjuster.html
I suggest you build the small circuit to adjust the 5v signal of the MAP sensor so you can calibrate the fuel delivery.
http://www.angelfire.com/my/fan/MAP_adjuster.html
Trending Topics
#9
Junior Member
Join Date: Mar 2010
Location: Lugoff,South Carolina
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0 L Straight 6
response to stalling
I had an issue like that with my xj. I noticed that there was a ringing noise coming from the fuel tank.....shortly after the ringing started the jeep stalled. I replaced the fuel pump and haven't had the issue since.
#10
Newbie
Thread Starter
Join Date: Nov 2008
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
fixed it
turns out i had a chunk 'o carbon holding my egr valve open this the crappy fuel mileage and the low idle/stalling problems as far as the noise it's now gone but i never figured out what that was
Thread
Thread Starter
Forum
Replies
Last Post
Programbo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
23
05-23-2024 07:20 AM
cdf43
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
09-09-2015 02:47 AM
jmarzo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
09-02-2015 08:29 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)