97 Jeep cherokee rough and rich idle - miss's at cruise speed?
#16
Newbie
Thread Starter
Thanks, compression check has been suggested but have not got there yet, need to get hold of a gauge.
It does not seem to mis under initial load, eg my driveway is steepish and if pulls up it without any hesitation and feels really strong. the mis really shows itself when at cruise speed, any cruise speed. but less then what it was before I out the new cps in.
also it did run well initially after sitting, and at one stage was pulling just over 8 k's per litre. Everything it has been doing seems to vary. eg when the computer was reset the first few times it cleared right up and went like a train. Now that the mis has settled in, although now less with the new cps as mentioned above.
feels lumpy also, surgy.
maybe a faulty MAP?
or maybe its the main computer playing up.
It does not seem to mis under initial load, eg my driveway is steepish and if pulls up it without any hesitation and feels really strong. the mis really shows itself when at cruise speed, any cruise speed. but less then what it was before I out the new cps in.
also it did run well initially after sitting, and at one stage was pulling just over 8 k's per litre. Everything it has been doing seems to vary. eg when the computer was reset the first few times it cleared right up and went like a train. Now that the mis has settled in, although now less with the new cps as mentioned above.
feels lumpy also, surgy.
maybe a faulty MAP?
or maybe its the main computer playing up.
Jeep is now running well, no miss, have to check economy at next fill up so fingers crossed, sems like it may have been the CPS, missed for a bit afer install, and now seems to be good.
Thanks for advice from fellow Jeep owners.
Thread
Thread Starter
Forum
Replies
Last Post
XJ ONLY
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
01-26-2019 06:30 PM
Ashs1714
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-04-2015 10:14 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)