99 Cherokee electrical mystery
#1
Newbie
Thread Starter
99 Cherokee electrical mystery
I’ve had my computer replaced about 3-4 times now over the past year and a half. Same thing every time, replacement good for about 6-8 months. The reoccurring problem is the guages will suddenly jump around, go dead and cause engine to misfire like crazy and sometimes stall. I’ve brought to shop for diagnostics for them to find nothing and send me out the door with a new computer. I would hate to sell as I’ve had it for some time now. Anyone with a similar problem or has been down this road? Codes show. Are both tcm codes 1694 and p1698.. any feedback is great
The following 2 users liked this post by fb97xj1:
IJM (11-16-2021),
Ineedhelpp (11-15-2021)
#3
Newbie
Thread Starter
All grounds on block and around engine bay that I know of have been removed and cleaned, I doubt it is just a bad ground as the problem will come and go randomly, this all started after a bad alternator was installed and likely surged out my computer on startup as the connectors on the back of the alternator where burnt off, I’m thinking it may have some correlation?
#4
Newbie
Thread Starter
Found the o2 sensor wires draped over my driveshaft while double checking grounds as I do have an o2 code. Could this possibly be grounding out and causing my computer problems? I will splice them back or get a new sensor anyway. Any feedback is great thanks
Thread
Thread Starter
Forum
Replies
Last Post
OldEd
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
07-16-2021 09:38 PM
jamaicanmecrazy
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
17
10-22-2008 10:29 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)