Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here XJ (84-01)
All OEM related XJ specific tech. Examples, no start, general maintenance or anything that's stock.

all these posts of water gettin to the pass floor but nobody says what it was!!

Thread Tools
 
Search this Thread
 
Old 05-08-2010 | 06:21 PM
  #1  
huntingman2706217's Avatar
Thread Starter
MJ>XJ
 
Joined: Mar 2009
Posts: 17,836
Likes: 5
From: Griffin, G.A.
Year: 1990
Model: Comanche
Engine: 4.0 I6
Default all these posts of water gettin to the pass floor but nobody says what it was!!

my comanche i just picked up leaks water on the pass floor... most peoples XJ's that i know do this also... mine does it to... but since mines for offroad use its just stripped floors and drain plugs pulled so i dont care... but on this MJ i want to fix it... what have you guys found it to be? only does it when it rains... NOT heater...
Old 05-08-2010 | 06:45 PM
  #2  
xj_maniac_newb's Avatar
CF Veteran
 
Joined: Sep 2009
Posts: 6,322
Likes: 6
From: Summerville, Ga
Year: 1995
Model: Cherokee
Engine: 2.5 4 cyl.
Default

im the only person i know of to have solved this problem....
ok what ur gonna have to do is pull the carpet up a little on the side to get up ALL the wate, cause i had the carpet to where it felt completely dry, but the insulation stuff was still soaked. Now once you get that done, check at your quarter panel, the antennae wire comes out of a whole about the size of a coca cola two liter bottle top and has a rubber plug that the wire goes through. That plug on mine had came out, but i don recommend just putting it back in. The problem with the wire is that it channels water directly into your passenger side floor, so what i would do if were you is to push the wire in some so that it has a loop hanging down so water doesnt just pour in, then take a flat piece of rubber and some silicone and seal it up.

then there may be one more problem, check the seal around the hood hinge, mine had a little water go in there when i tested it, but i did spray it directly in the hood seal thing. Also, a side note, you have to have to take the quarter panel and the step panels to get to the hole.


also, my door seals leak a little, but the only way that can be fixed is with some silicon or new door seals

hope that helps

Last edited by xj_maniac_newb; 05-08-2010 at 06:48 PM.
Old 05-08-2010 | 06:50 PM
  #3  
alpine.adrenaline's Avatar
CF Veteran
 
Joined: Aug 2009
Posts: 1,127
Likes: 12
From: 9000 ft, CO
Year: 1999 XJ
Model: Cherokee
Engine: I6 4.0L
Default

I'm subscribed. I keep putting off fixing mine so I'm interested in any thoughts on this and I might tackle it tomorrow. I've heard you should check your windshield seal at the base, but I don't know why it would so frequently happen on just that side. Might have to have a friend pour a cup of water over several areas until you can trace it.
Old 05-08-2010 | 06:50 PM
  #4  
xj_maniac_newb's Avatar
CF Veteran
 
Joined: Sep 2009
Posts: 6,322
Likes: 6
From: Summerville, Ga
Year: 1995
Model: Cherokee
Engine: 2.5 4 cyl.
Default

sorry for the long reply, just figured id give all the info i know up front
Old 05-08-2010 | 06:53 PM
  #5  
huntingman2706217's Avatar
Thread Starter
MJ>XJ
 
Joined: Mar 2009
Posts: 17,836
Likes: 5
From: Griffin, G.A.
Year: 1990
Model: Comanche
Engine: 4.0 I6
Default

cool ill have to check these... i finally found a thread already... but seem like theres several different fixes for everybody... everyones different i guess... so gonna have to break out the hose and fine mine... also mines got the rubber floors so its not hurting much... lol... no carpet...
Old 05-08-2010 | 06:54 PM
  #6  
huntingman2706217's Avatar
Thread Starter
MJ>XJ
 
Joined: Mar 2009
Posts: 17,836
Likes: 5
From: Griffin, G.A.
Year: 1990
Model: Comanche
Engine: 4.0 I6
Default

heres the other thread i found...
https://www.cherokeeforum.com/f2/wat...-14836/index2/
Old 05-08-2010 | 08:29 PM
  #7  
xj_maniac_newb's Avatar
CF Veteran
 
Joined: Sep 2009
Posts: 6,322
Likes: 6
From: Summerville, Ga
Year: 1995
Model: Cherokee
Engine: 2.5 4 cyl.
Default

awesome. so jealous of the rubber floors lol
Old 05-08-2010 | 08:45 PM
  #8  
huntingman2706217's Avatar
Thread Starter
MJ>XJ
 
Joined: Mar 2009
Posts: 17,836
Likes: 5
From: Griffin, G.A.
Year: 1990
Model: Comanche
Engine: 4.0 I6
Default

both these MJ's i got have them and so do the ones in the local JY... almost can say there standard... lol
Old 05-08-2010 | 08:48 PM
  #9  
truckntractorhick's Avatar
CF Veteran
 
Joined: Dec 2009
Posts: 2,091
Likes: 1
From: Harleysville, PA
Year: 1998
Model: Cherokee
Engine: 4.0L I6 Powertech
Default

my jeep had this and it turned out to be the windshield seal on the top left (lookin at it head on) so i taped it with electrical tape and havent had a problem since!
Old 05-09-2010 | 07:16 AM
  #10  
chastings's Avatar
Newbie
 
Joined: May 2010
Posts: 25
Likes: 0
Model: Cherokee
Default

X2 on the antenna grommet; had the windshield seal replaced which did not fix it. After popping off the kick panel, I realized the antenna grommet popped out, I pushed it back in, coated with atv and hasn't leaked at all since.
Old 05-09-2010 | 08:36 AM
  #11  
R Cannon's Avatar
Seasoned Member
 
Joined: Nov 2009
Posts: 495
Likes: 0
From: PA
Year: 1996
Model: Cherokee
Engine: 4.0 HO
Default Blower motor?

I had that problem. I Replaced my blower motor and RTVd the gasket. So far so good.
Old 05-09-2010 | 08:40 AM
  #12  
huntingman2706217's Avatar
Thread Starter
MJ>XJ
 
Joined: Mar 2009
Posts: 17,836
Likes: 5
From: Griffin, G.A.
Year: 1990
Model: Comanche
Engine: 4.0 I6
Default

see... like 50 different reasons... i just always thought it was pretty much the same for everyone but after reading this and the old post its pretty much different for everyone... lol... i used the antenna hole on my cherokee to run my fog light wires through and such... so thats probly my leak in it... lol
Old 05-09-2010 | 08:53 AM
  #13  
davida's Avatar
Seasoned Member
 
Joined: May 2009
Posts: 296
Likes: 1
From: Wy & OK
Year: 83 CJ7 & '96 XJ & '97 XJ
Model: Cherokee
Engine: 258ci, 4.0 & 4.0
Default

My 96 leaked at the pass side bottom windshield every time it rained. Once I got a crack in it I decided to get it replaced, after the new windshield was installed it still leaked, the co that installed it made a comment that they sometimes had trouble getting them to seal in that location on Cherokee's. The second time they got it and it has not leaked since.
Old 05-15-2010 | 08:46 PM
  #14  
dejr2000's Avatar
Newbie
 
Joined: Jan 2010
Posts: 8
Likes: 0
Model: Cherokee
Default

Looks like I found the source of my leaks today. First and worst was on the drivers side. When it rained water enters the cowl area and should drain out but it found it's way in through an unsealed body seam from the factory. I've attached pics but didn't think to snap any before I sealed and painted the area but you'll get the idea. The water leaked out of the cowl area and dripped onto the wiring junction block and leaked into the drivers side floor. Blue circled area shows where leak water came from and yellow show where it dripped to and proceeded into the inside of XJ. I pulled cowl panel and sealed area from the inside as well as the area you see painted black.



I have found a similar leak on the passenger side and will show it unrepaired but you'll see where the water is seeping. The passenger side area is just above the washer bottle and when water leaks in this area it is dripping onto and leaking around blower motor so still need to reseal this area but I've at least located my source. Tomorrow will seal seam and reseal blower motor as it need to be replaced anyway.

Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Psiegrist1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
34
03-17-2022 03:15 PM
93civEJ1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
10-02-2019 05:08 AM
shelby5041
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
39
11-07-2015 02:22 AM
sikkev
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-06-2015 12:33 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -5. The time now is 10:28 PM.