ATF for AW-4 Q!?
#31
Beach Bum
Guess I will not be dropping the pan again. Yea!
#32
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,971
Received 1,562 Likes
on
1,266 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
Save yourself the headache. Yea!
And BTW, quit cluttering up this thread with facts and hands-on experience. LOL.
Last edited by cruiser54; 04-27-2014 at 08:50 AM.
#33
Junior Member
Thread Starter
Join Date: Dec 2012
Location: Australia
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996 (Built'95)
Model: Cherokee
Engine: 4.0L Petrol
Okay, took me all day today to wrestle around, but I finally managed to change the screen and the gasket on the AW4 pan. Question I have is for checking the level, I nearly put 3.9L in and its running okay (quick drive) but what is the correct procedure to check the HOT AT fluid Level. Following procedure was used and I would appreciate if you can point out the error.
1. Run the cold engine at idle for 5 minutes and during that time, I shifted from P to 1/2 and back till all gear engaged with parking brake and foot brake on.
2. Engine still idle and engine temp has reached 100C, if I check AT fluid level with engine running it is not on the FULL mark on the Hot side of the dipstick.
3. If I turn the engine off and wait for 60 seconds and then check the dip stick, the HOT side of the dip stick is showing FULL.
So, do I have the correct amount according to the dipstick or not?
Note - For those confused between a Filter or Screen, after actually doing this DIY, I say it is a Screen to block larger particle entering into the AT and does not perform any sort of dirt filteration on the oil. Also, I thought the screen would have been on the pan, but it is actually bolted to the valve body/AT with 4x10mm bolts with two rubber sealing in the middle for support.
1. Run the cold engine at idle for 5 minutes and during that time, I shifted from P to 1/2 and back till all gear engaged with parking brake and foot brake on.
2. Engine still idle and engine temp has reached 100C, if I check AT fluid level with engine running it is not on the FULL mark on the Hot side of the dipstick.
3. If I turn the engine off and wait for 60 seconds and then check the dip stick, the HOT side of the dip stick is showing FULL.
So, do I have the correct amount according to the dipstick or not?
Note - For those confused between a Filter or Screen, after actually doing this DIY, I say it is a Screen to block larger particle entering into the AT and does not perform any sort of dirt filteration on the oil. Also, I thought the screen would have been on the pan, but it is actually bolted to the valve body/AT with 4x10mm bolts with two rubber sealing in the middle for support.
#34
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,971
Received 1,562 Likes
on
1,266 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
The directions for checking the fluid level are on the dipstick.
#35
Junior Member
Thread Starter
Join Date: Dec 2012
Location: Australia
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996 (Built'95)
Model: Cherokee
Engine: 4.0L Petrol
Thanks for the direction, in short I should be checking the ATF fluid level after 15KM ride at idle with engine running. I was little low but at the same time I am leaking a little oil so before I top up, I better check where it is leaking from.........
Must say, your direction was very accurate. Thanks!
Must say, your direction was very accurate. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
xjcarolina
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
09-29-2015 08:43 PM
Zerocyde
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
09-19-2015 02:18 AM
ariff
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
01-30-2011 09:10 AM
cfh0225
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
01-30-2010 10:48 PM
tmims
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
11-24-2009 08:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)