AX-15 Swap
#1
Newbie
Thread Starter
Join Date: May 2018
Location: Suffolk, VA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee (XJ)
Engine: 4.0
AX-15 Swap
I'm in the middle of doing a ax-15 swap in my 88 Cherokee. I got the ax-15 out of a 91 Cherokee so I ordered the clutch set and flywheel for a 91. But I was comparing the old flywheel to the new one and the reluctor wheel is different between the two. Will the 91 flywheel work or do I have to use one for an 88?
#2
Newbie
Join Date: Oct 2017
Location: Montana
Posts: 18
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1988
Model: Cherokee (XJ)
Engine: 4.0L
Since none of the experts have chimed in I will give it a shot. I think you need the 88 flywheel, that is what I used when doing the swap on my '88. Think you need it for the renix cps to work correctly, think 91 may not be renix (forget exactly when the switch happened). Hope this helps.
#3
Newbie
Thread Starter
Join Date: May 2018
Location: Suffolk, VA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee (XJ)
Engine: 4.0
That's kinda what I was thinking but I wasn't sure. I new to the Cherokee game. I'm used to the simplicity of my carbureted Wrangler. I appreciate the help.
#5
CF Veteran
Join Date: Mar 2010
Location: Broward County Fl.
Posts: 47,923
Likes: 0
Received 29 Likes
on
28 Posts
Year: 1989 xj sport 2dr
Model: Cherokee
Engine: 12 hole bosch Injectors
Also pilot bearings not gonna work unless pilot shaft are same size on new and old trans. Call Novak Adapters they carry the correct one to do the swap.
Last edited by freegdr; 05-29-2018 at 05:10 AM.
Thread
Thread Starter
Forum
Replies
Last Post
skinnyg
Modified XJ Cherokee Tech
13
12-24-2014 08:32 AM
zebaffe
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
11-06-2013 03:57 PM
manny
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-06-2010 12:01 AM
XJ94
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
02-28-2010 07:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)