i broke a hinge pin puttin my door back on. anybody know how i can get it out?

 

stuck in the door or the cab part?

 

door.

 

just grab another from the JY for acouple bucks i u cant get it out...

 

i don't have a way to get to a JY. and it has to come out somehow. think i can drill it out?

 

naw... cause that will hollow out the hinge... try a long skinny center punch... and a hammer...

 

i tried that o.O but now i have it in a vice and i will try again.. what did u use for passenger hing pins?

 

most people use grade 8 bolts...but i cut off my lower hinge first then pulled the doors off and that kept the pins in the top part of my hinge... so i just drilled out the holes on the jeep part and use the same pins... lol... i need to cut the pins shorter now though... they still hang down like where the old part of the hinge was... makes it harder to line up the pins with a heavy dang door....

 

Retracting! Edit: Not sure my reply was on the same page. I was thinking door check pin.

 

i used clevis pins for my rear doors.. like this one-



i dont remember the size off hand but it fits PERFECT. tapped out the broken pin and slid the pin in place. i used red loctite to hold them in, and they've been there for almost 2 years no issues. if you have access to a welder a tack on the pin would work better than loctite.

 

yeah but my problem is the "tapping the broke pin out" it wont budge!

 

bigger hammer. Driverside hinge pin should be driven upwards, passengside downwards.

 

I couldn't even get my pins out so I said eff it and left the original doors on instead of changing to my better doors.

 

well these are my factory doors. my moms bf is going to take the hinge to work tomarrow and do something to it thier to get it out. i need to find something that wont break to use as pins an ideas?

 

Do you have a torch? heat up the hinge and go BFH.