Can't remove steering stabilizer nut
#2
It looks too rounded to get an open end wrench on it. Hacksaw or sawzall between the head of the stablizer and the bracket to cut the bolt. Or cutoff wheel on the head of the bolt, knock it inwards and you should have enough room to angle the bolt out the nut side. The bolt and nut need replaced anyway.
The following users liked this post:
Kuro89 (Today)
#3
**** me dead
I cant believe what I see on the underside of (presumably) salt affected US roads ?
You could turn my XJ upside down, make it into a dinner table, and eat your salad off the underside, no plates needed
If I was you, I would buy a butane torch, save you HOURS
I cant believe what I see on the underside of (presumably) salt affected US roads ?
You could turn my XJ upside down, make it into a dinner table, and eat your salad off the underside, no plates needed
If I was you, I would buy a butane torch, save you HOURS
Thread
Thread Starter
Forum
Replies
Last Post
blaynecs
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
05-16-2020 07:01 PM
Kuya
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
05-13-2016 04:00 PM
Crow Horse
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
04-16-2011 09:44 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)