Jordenrice

So I got a 92 4.7 stroker aw4 4wd. Just finished the stroker build a few months ago and had about 3 weeks of driving until I lost power to everything I only have power to headlights and hazards I’ve cleaned grounds, checked and replaced fuses replaced nss and ignition switch, my door buzzer still goes off so that tells me the ignition is recognizing the key. Any ideas are greatly appreciated on what to check next
starter is brand new and I’ve done the screwdriver truck and it cranks just fine

Gone_Rabid

Do you have power going to ignition switch and then out of the ignition switch at accessory and start?

if not I would assume ignition switch even if you put one in.

follow the voltage.

Jordenrice

Not sure but just put new ignition switch and dash harness in the jeep

tlc1976

I say check ignition switch too. Seems most likely considering what works and what doesn’t. Sometimes new parts have defects.

awg

circuit diagram and test light