jeepguy93

I got it to like 85% and 15% tuned and Cps reads 5.2 ac volts

cruiser54

85%? That's approximately the setting for the square trans connector. What about testing and setting it off the flat 3 wire connector at 17% of input voltage?

jeepguy93

Yes it was 85 percent on the Foursquare and 15 percent on 3 prong

lukeincolorado

Its your o2 sensor. Mine did the same thing, everytime I would press in the clutch to stop it would die or almost die.

jeepguy93

It's a new o2

jeepguy93

Could it be the ignition control module??

cruiser54

Percent of what? Which instructions are you using?

jeepguy93

On the thing you gave it said needs to be 83% of what you first tested and then 17 percent on the other prom connector of what you first tested. When I can get the first 1 was 85 percent of what I first tested and then the second prongconnector was 15 percent

cruiser54

Couldn't get 17% of input voltage on the 3-wire connector? What was your input voltage BTW?

jeepguy93

It was late and we got it close, working again at it thurs.. I can't remember imput

sam.bellet

Yea my o2 sensors are newish and they went bad

jeepguy93

I mean we replaced the o2 sensor 2 days ago

jeepguy93

Needed another new tps and retune it and a new pcm! Now it runs amazing no stutter, no bad idle and no bad hiccup !! Drove a 14 hr. roundtrip and 900 miles no issue!