Exaust manifold
The following users liked this post:
cruiser54 (06-23-2020)
#3
CF Veteran
Almost all the cheap and affordable pieces will have the wrong header flange thickness.(ebay or dorman)They will be thin and cause the shared conical washers to be offset. This creates an issue with clamping the exhaust correctly. You could try a remflex gasket to help with this or weld washers on the tabs to even out the difference.
#4
Old fart with a wrench
He didn't say cheap, he said best! Stay away from Dorman junk anyway. I used a good one on my 97 ZJ that had expansion sections in the runners from the #1 and #6 cylinders that eliminate cracking at the collector, but that was so long ago I don't remember who made it except I got it from Rockauto.
Last edited by dave1123; 06-22-2020 at 09:47 PM.
#5
CF Veteran
The parameters of "best" were not given. Value to cost excludes Thorley and banks. Not enough performance to justify the cost.
#6
Newbie
Thread Starter
Join Date: Jun 2020
Location: Az
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee (XJ)
Engine: 4.0
Replacement exaust manifold, I'm just trying to find the best OE replacement.
Can anyone tell me the best OE replacement. How is crown, omix, money is not an issue. This is not an easy job don't want to do it again in a year.
#7
Newbie
Thread Starter
Join Date: Jun 2020
Location: Az
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee (XJ)
Engine: 4.0
Exaust manifold
Can someone please tell me the best OE exaust manifold to buy. Money is not an issue. I just don't want to do it again. Would you recommend dorman, ATP, omix or crown. I'm doing this job for a friend of mine and I don't want her to have to do it again. It's a stock motor 4.0 liter. 1992 Cherokee xj
Trending Topics
#9
Old fart with a wrench
looking at the Rockauto list, I think I used the one from SKP.
#10
CF Veteran
Join Date: Aug 2019
Location: Littleton, CO
Posts: 1,451
Received 260 Likes
on
201 Posts
Year: '96
Model: Cherokee (XJ)
Engine: 4.0 HO
Theres a lot of threads on this subject. Just do a search and read several of the threads and see which names come up the most. I'm not familiar with the subject, but just noticed a lot of threads about exhaust manifolds and flex pipes.
#11
CF Veteran
Join Date: Aug 2019
Location: Littleton, CO
Posts: 1,451
Received 260 Likes
on
201 Posts
Year: '96
Model: Cherokee (XJ)
Engine: 4.0 HO
Why dont these manufacturers make those pipes a little more angled so the flow is improved, rather than welding them almost perpendicular to the main pipe... Seems to me like it would cause a little bit of restriction and not very smooth flow the way the weld them on now....
#12
Old fart with a wrench
You can buy a header system if you like....for a couple of hundred dollars.
#14
Old fart with a wrench
Actually, the whole point is moot. Have you seen the size of the exhaust ports in the 0331 head? I think they are smaller than the valve!