Frankz
12-03-2009, 08:11 PM
#2
Looks good. A couple suggestions for ya.
1.) Add a couple of welds on one or two of the flats of the nut to keep from pushing the tool past the adjuster.
2.) Build another one. Swapping one from side to side is a pain the butt. Having two makes the job a lot easier and faster.
1.) Add a couple of welds on one or two of the flats of the nut to keep from pushing the tool past the adjuster.
2.) Build another one. Swapping one from side to side is a pain the butt. Having two makes the job a lot easier and faster.
Thread
Thread Starter
Forum
Replies
Last Post
SeriousOffroad
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
12
06-18-2010 11:10 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)