231James

Does anyone know what these to connectors are for? Rebuilding jeep and can’t remember and did not mark any of them unfortunately.

These two don’t seem to have a home


This one is in the battery compartment area, not sure what it would plug into.

awg

One way is to free download the FSM from Cruise54 website, as it has connector locations and pinout, so you can ID them

I will throw out some wild guesses and say the battery one may be for the "battery temp sensor" which is located in the battery lower box, and those 2 near the oil filter, I think there is a bunch of 4 connectors that connect to the trans and TX case in that area, check the harnesses up from below

hint; different colored tags, or even tape, preferably written on are helpful...but you already know that

231James

Thank you

231James

So the 4 pin ended up being oil pressure. I assumed I had that plugged in so that was dumb. Found out the hard way for going through the manual. Thanks again. Didn’t know one existed online.