Kick down cable
#1
Seasoned Member
Thread Starter
Join Date: Aug 2009
Location: Roanoke, Va
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Kick down cable
How do I adjust it? I need to make sure it tight to spec. Everytime it's in 4th gear and when I go up hill, it won't change it until my gas pedal is almost all the way to the floor. So, I need to adjust it or check it.
#2
#4
CF Veteran
To adjust the TV cable you:
1: Push in and hold the release button
2: While holding in release button, push "conduit" in as far as it will go
3: Release button
4: Rotate throttle to WOT, some people do this with the gas pedal. Others do it from the engine compartment.
5: Hold at WOT for a few seconds, cable should ratchet out a click or two.
6: Your TV cable should now be properly adjusted, take it for a test ride.
Here is another post about it on NAXJA
http://www.naxja.org/forum/showthread.php?t=1015963
#5
This will help. >-> https://www.cherokeeforum.com/f2/free-quick-fix-41821/
and if i can tis th etranny kick down cable attached to the tranny inside ? do i need to drop tranny pan?
#7
yes.. you have to drop the trans pan?? so i gotta drain fluid all that bull just to replace the cABLE?? i hav a 97 cherokee sport. 4.0. 4wd. i heard its along side the left side of the tranny?
im also asking if its possible to just go to junkyard to get black clip and dremel off the old crimp and recrimp with a new end crimp.. that seems to be the easiest by far. im not droppin my pan.. is it really nesscary??
Last edited by LiFteDLiFe97; 04-10-2010 at 06:50 AM.
Trending Topics
#9
yea im gunna go ahead a replace the entire cable tommorrow. 37 bucks from dealer. my black clip broke so i dremeled off the crimp and recrimped the cable but its like a k*nt hair too short.. gunna do a tranny filter also while im in there.. somehting as critical as the tranny cable its worth for me as i see it to have a fresh cable..
#10
Member
Join Date: Apr 2010
Location: Marion, IN
Posts: 150
Likes: 0
Received 2 Likes
on
1 Post
Year: 2001
Model: Cherokee
Engine: 4.0
To adjust the TV cable you:
1: Push in and hold the release button
2: While holding in release button, push "conduit" in as far as it will go
3: Release button
4: Rotate throttle to WOT, some people do this with the gas pedal. Others do it from the engine compartment.
5: Hold at WOT for a few seconds, cable should ratchet out a click or two.
6: Your TV cable should now be properly adjusted, take it for a test ride.
Here is another post about it on NAXJA
http://www.naxja.org/forum/showthread.php?t=1015963
#11
Senior Member
Join Date: Dec 2009
Location: Southeast Michigan
Posts: 598
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: i-6 4.0
it will only go one way, twist it till it stops
#14
Junior Member
Join Date: Nov 2010
Location: Nebraska
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Cherokee
Engine: 4.0 H.O.
Is the cable supposed to travel after adjusted. I adjusted mine and it when I got done with the test drive, it traveled back out.