metal shavings in oil pan
#61
Senior Member
Thread Starter
Join Date: Jan 2012
Location: High Desert AV
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
Year: 88
Model: Cherokee
Engine: inline 6 4.0 liter renix
Last time I used aluminum rails from a sliding glass door. I suppose nice straight 1x4 could work. I wired the aluminum loosly, right in the center.
You measure across right at center level, front and back. Mine has a tie rod connecting the steering knuckles. You loosen the clamps and rotate the whole rod to screw it longer or shorter. Sory, I don't remember which tie-rod end has left hand threads. If you make the front reading 3/32-1/8 of an inch less than the rear that should do. I always double check after rolling it.
With a helper you can just use the tire tread and a tape, just be sure to measure from the same place on the tread.
Btw, you want to check for wear/slop on the rest before adjusting it! (TRE's) especially.
You measure across right at center level, front and back. Mine has a tie rod connecting the steering knuckles. You loosen the clamps and rotate the whole rod to screw it longer or shorter. Sory, I don't remember which tie-rod end has left hand threads. If you make the front reading 3/32-1/8 of an inch less than the rear that should do. I always double check after rolling it.
With a helper you can just use the tire tread and a tape, just be sure to measure from the same place on the tread.
Btw, you want to check for wear/slop on the rest before adjusting it! (TRE's) especially.
Thread
Thread Starter
Forum
Replies
Last Post
scoutmstr
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
04-06-2016 11:14 AM
MidwestNick
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
02-28-2016 02:05 AM
Blackxj51
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
22
09-13-2015 06:06 PM
Blackxj51
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
09-13-2015 02:07 PM
Currently Active Users Viewing This Thread: 3 (0 members and 3 guests)