So I have had my eye on the Dynomax Super Turbo from summitracing. After browsing around and listening to different clips on youtube..ha..I think I am going to try out the Flowmaster Super 44 instead. While replacing the muffler I figured I would go ahead and replace the tail pipe as well so far this is what I have found its just OEM replacement.
http://www2.partstrain.com/store/?N=...%20Tail%20Pipe
Link to Flowmaster:
http://cgi.ebay.com/ebaymotors/ws/eB...ksid=p3907.m32
So should these work together and should this all be a direct bolt on replacement? From what I am reading everything should just bolt to each other and back onto the Jeep.
Thanks for any input. I have decided on this route because it seems to come out a bit cheaper than the Dynomax kit from Summit.
The funds are starting to get cut by the wife.

 

As long as you get the 2.25" In/Output for the muffler I believe it'll work out just fine. I was looking at the Super Turbo too, I did the same by going to YouTube, not impressed. It sounds too...high pitched? IMO

 

I agree It should be fine, also watch your inlet and outlet locations. Some enter in the center exit on the right and some enter on the left and exit center. Just order your muffler same as stock.

 

Yea I found some on youtube that sounded weird and some that didn't sound to bad. Yea I am going to go crawl under the Jeep later today and make sure I order the inlets and outlets in the right spots.