I am trying to find a replacement tailpipe for my 2000 4.0 stock DD. The suggested Walker replacement (55188) is 2 inch ID. with the muffler I am using being the stock 2 1/4. Does anyone have a suggested brand or a better walker part number? I do not have a welder so whatever I do it has to a clamp system. I dont want to use an adapter if I can avoid it.

 

put a turn down on the muffler output and call it a day. Just my two pennies

 

I agree thats what my plan on my rig, dumping at the muffler

 

Haha, mine too gots myself a slowmaster in the mail and a turn down in the garage.

 

That's what I have too. I just bent a piece of pipe and cut it to make a turn down. Works just fine. Drone isn't bad unless doorless in OD going like 35 lol

 

Ohh I want mine loud! The louder the better. I got a magnaflow but I still havent figured how to hang it. How did you do it? This is the only holdback I have, any cheep ideas?

 

Trying to avoid breathing CO if I can!

 

With a turn down the fumes will still get away from the cab, just make sure to weld the system up and the velocity of the exhaust will carry itself out from under the Jeep. A tailpipe is just not worth the hassle IMO, i have one (Put on a Flowmaster super44 and the same tailpipe you're getting) and all it does is rattle n' leak.

In fact, I'm thinking of doing a turndown myself.

 

I want the turndown cuz I want my jeep loud, I think if do a dump at the muffler my opinion its going to get louder. And for me loud is good!

 

Not really, It'll be slightly louder in the cabin and maybe cause a little cab drone (Depends on what muffler you have), but it won't be any louder outside.

 

I don't know about where you live but most muffler shops around here will bend up a tail pipe and weld it on for what it'd cost for you to buy one from Walker...

For what it's worth, I run a turn down at the muffler on my trail rig and run a tail pipe on my DD Jeep.

 

Maybe you can help me work my new exhaust out. I have a 2-1/2" magnaflow muffler at the front end I have a BANKS revolver header, I want to re do my exhaust system. Any suggestions?

 

Replace the down pipe off the header if you haven't already, that's all i can suggest lol.

 

When I replaces my cat converter I had to replace the whole kit and kaboodle. It was all rusted together. A bought all walker parts and it turned out to be rather inexpensive. Probably around 250-300. I was expecting it to cost alot more.

 

But I seen my collecter and It wasnt a pretty sight its a shame I got such a badass header I was looking at a mandrel bent exhaust DIY kit on ebay for $+180 shipped to my door. Soooo im thinking 2-1/2" from collector, cattless, to my magnaflow and dumping at muffler. All smooth mandrel bent exhaust system 100% OPTIMUM FLOW! but my ears are open if you got cheap ideas