89 xj. planning on dropping the transfer case. thinkin the sye kit will come later when a have a place to work/abit more knowledge. just had a question for someone that has around the same situation as me. 6.5 lift in the front 8.5 in the back. if i put in 2 inch spacers for the tcase cm then would that be good enough? bigger spacers? smaller? hows that going to affect the linkage for the shifter?
any help is great thanks.

 

i have a all around 6.5" lift with a 1" tc drop that works just fine

 

if your running an 8.5 in the rear, you should prolly have Some shim spacers in the rear so your pinion angles are a little more parrallel... but i wouldn't go over an inch with drop t-case setups... yes it can throw off your linkage setup...

what are you running for control arms upper and lower in the front?