If I'm driving slowly in four wheel drive and in reverse, such as backing into a parking spot, something occasionally slips and it's like I'm in neutral. Shifting back to two wheel drive works fine.

I've only noticed it in reverse and four wheel.
Any thoughts, ideas, suggestions before I open up the transfer case and take a look around?

 

Which t-case is it?

 

Np242

 

Its probably popping into neutral because its not fully in 4WD. Try realigning the shifter so that you can more fully shift into 4WD. You need a buddy to push the shifter forward and pull it back in order to find the true travel and dial it in

 

Good question right here..

try adjusting transfer case linkage.

 

I'll mess with around a little bit and get back with some results. Hopefully I can get to it soon, thanks for the input.

 

Shifting the NP/NV242J Selec-Trac Transfer Case

2WD Position
This position is for driving on hard-surfaced roads under normal driving conditions when 4-wheel drive is not desired.

4x4 PART TIME Position
This position is designed for temporary use of 4-wheel drive when on-or off-road conditions such as deep snow or heavy ice require increased traction. When engaged, both the front and the rear axles are mechanically locked together and turn at the same speed. Do not use 4x4 PART TIME on dry, paved roads.

To engage, shift transfer case from 2WD to 4x4 PART TIME while the vehicle is moving at any legal speed.

An amber PART TIME lamp will illuminate on the instrument cluster when 4x4 PART TIME is selected.

4x4 FULL TIME Position
This is the primary 4-wheel drive position, which offers better traction when roads are wet, snow covered or icy. When engaged, the front and rear wheels axles are permitted to turn at different speeds to enhance maneuverability. Use 4x4 FULL TIME year-round on all road surfaces if you wish.

To engage, shift transfer case from 2WD to 4x4 FULL TIME while the vehicle is moving at any legal speed. When shifting, do it in a swift and firm movement.

When shifting from 2WD through 4x4 PART TIME to 4x4 FULL TIME, two momentary releases of the accelerator may be required after shifting.

A green FULL TIME lamp will illuminate on the instrument cluster when 4x4 FULL TIME is selected.

4 LO Position
This position is designed for temporary use of 4-wheel drive when off-road conditions require added low speed pulling power. Do not use 4 LO on dry, paved roads.

To engage, slow the vehicle to 2-3 mph (3-5 km/h), shift the transmission into Neutral (N), then shift the transfer case lever to Neutral, then to the right and pull firmly rearward to 4 LO.

Never attempt to engage Low Range when the vehicle is moving faster than 2-3 mph (3-5 km/h). Transfer case damage may result.

An amber PART TIME lamp will illuminate on the instrument cluster when 4 LO is selected.