When cold engine cuts out at low rpm.
#1
When cold engine cuts out at low rpm.
So here recently my jeep has started acting up. When it sits for awhile and cools off it cuts out bad for about the first minute of driving. I can't hardly go past 2000 rpms. Once it starts to warm up it does fine. I had issues sort of like this a few weeks ago and it ended up being a bad map sensor. I have replaced cps, iac, map, upper o2, new plugs wires and cap. Any idea what it could be? The battery seems to be going bad and plan on replacing that in the next day or two.
Thanks
Thanks
#2
::CF Moderator::
Joined: Aug 2011
Posts: 43,971
Likes: 1,565
From: Prescott, Az
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
Thanks for your post.
We’re here to help but you must understand that all Jeeps are not the same.
In order for us to give you more accurate advice and help, we must know the following, as applicable, along with detailed information as to the symptoms/problems etc:
Year
Model
Engine
Transmission
Transfer case
We’re here to help but you must understand that all Jeeps are not the same.
In order for us to give you more accurate advice and help, we must know the following, as applicable, along with detailed information as to the symptoms/problems etc:
Year
Model
Engine
Transmission
Transfer case
#5
::CF Moderator::
Joined: Aug 2011
Posts: 43,971
Likes: 1,565
From: Prescott, Az
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
#6
Ya I was not going to go buy it just was unsure where it was. The cel light does not work (haven't had a chance to check it since I bought it) I may try taking it to autozone to see if it throws any codes at them. I replaced the battery and that didn't do anything.
Thread
Thread Starter
Forum
Replies
Last Post
Blackcherokee290
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
27
07-26-2022 08:52 PM
Ronw
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
3
09-02-2015 01:23 AM
hockeyfan_83
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
08-22-2015 11:27 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)