SouthSeaPirate

I have a loud whistle noise coming from the Evap area at highway speeds. It goes away when on anything other than recirculation selection on the AC.
What could be causing this?

SouthSeaPirate

Driving my crazy cause I cant drown it out with one blown speaker.

Cherokeegirl89

You might want to check to see if the pulley is ok, mine whistled and it was my ac pulley dying. It seized and broke my belt.

CCKen

When MAX AIR, Recirc, is selected the Recirc air door is open and the blower fan is right there. Maybe the blower fan is rubbing(?)


Roll the glove box down and you can see the Recirc air opening. Select MAX AIR (Recirc), turn the key to ON/RUN (engine off), select high speed on the blower, listen for the noise. Look inside the Recirc opening to see if the blower fan is rubbing.

SouthSeaPirate

Does it with AC off as well. No fan or compressor needed. Basically, I could say; the only time it doesn't do it (when at said speed) is when the A/C selector is on anything but off or recirc.

CCKen

Did you take a look at what I mentioned above?


Edit: I'm not good at reverse terminology. Could you state exactly what settings it does make the noise, instead of "the only time it doesn't do it".

SouthSeaPirate

It's easier to say when it doesn't. Realized that after your first post.

It is 100% wind noise. At 55+MPH noise happens (and at never speed below it); AC on or off. The only time it does not do it, when at speed, is when the AC is on anything other than off or recirc. So defrost, not recirc, basically when the door closes.

CCKen

Sounds like the foam seal around the air inlet has deteriorated. Air coming in the grill at the base of the windshield goes through a passageway to the blower chamber. See pic.


The Recirc air door closing off the outside air may be isolating it (?)


Pull the grill work off at the base of the windshield and try and see what's going on at the inlet.

SouthSeaPirate

Wish I knew to pay attention to this before I put it all back together. I vaguely remember foam looking good tho; could have been other places however.

I would love to get in there and make sure it's not something in the cowl inlet.
How do I get beyond this point?

SouthSeaPirate

After researching it looks as tho the only way to get to this is cut.

Ill see what I can see with the glove box removed.