Last edit by: IB Advertising
See related guides and technical advice from our community experts:
Browse all: General Overview
- Jeep Grand Cherokee WJ 1999 to 2004 Crash Test and Safety Ratings
Important Information to help you understand your Jeep Grand Cherokee.
Browse all: General Overview
XJ Ask the Question Thread
Banned
Join Date: Oct 2012
Location: USA
Posts: 1,744
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L i6
Herp Derp Jerp
Join Date: Nov 2011
Location: Parham, ON
Posts: 18,251
Likes: 0
Received 13 Likes
on
12 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L OBD-II
Is it in here somewhere?
https://www.cherokeeforum.com/f51/
https://www.cherokeeforum.com/f51/
CF Veteran
Join Date: Sep 2012
Location: Springfield Virginia
Posts: 1,289
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
On my 98 I had a very fast driver side blinker going. Found it was my on the bulbs on the indicator under the headlight. When I went to replace the bulb I noticed when I moved the bulb a bit it would work and the blinkers would operate fine. I'm guessing it's the pig tail to the light holder but can that just be spliced into the original wiring?
CF Veteran
Join Date: Oct 2011
Location: Summerville, South Carolina
Posts: 2,613
Likes: 0
Received 0 Likes
on
0 Posts
Year: 99
Model: Cherokee
Engine: 4.0
On my 99 it runs really hot. Not losing coolant. Temp gauge says its good. Just replace thermostat. But after a little while of running you can't even touch the hood. Why? Check engine lights on. My other jeep didn't do that
CF Veteran
Join Date: Jul 2009
Location: New Jersey
Posts: 2,522
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: l6 HO
Does the top rad hose get hot? You might have a blockage or a bad water pump. My 95 loved to run hot in the summers. Finally I threw a water pump at it a couple weeks ago and all is well.
Seasoned Member
Join Date: Sep 2011
Location: Muncie, Indiana
Posts: 464
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
Tcase drop
I am building my own 1'" Tcase drop I have no clue what the dimensions would be to cut for length and holes for bolts. I need it built before my lift goes on next saturday. also, does anybody know what size bolts are needed for the tcase with it dropped an inch? length and width?
thank you in advance,
seth
thank you in advance,
seth
CF Veteran
Join Date: Apr 2011
Location: Chickamauga Ga.
Posts: 3,493
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
Originally Posted by ksrummel
I am building my own 1'" Tcase drop I have no clue what the dimensions would be to cut for length and holes for bolts. I need it built before my lift goes on next saturday. also, does anybody know what size bolts are needed for the tcase with it dropped an inch? length and width?
thank you in advance,
seth
thank you in advance,
seth
New to the site. Hope someone can help with diagnosis. 1995 xj with front end noise at low speeds that sounds like bad speedo cable would . Some vibration in steering wheel. Bad clunking noise when in 4H. All u joints look good.
CF Veteran
Join Date: Oct 2011
Location: Summerville, South Carolina
Posts: 2,613
Likes: 0
Received 0 Likes
on
0 Posts
Year: 99
Model: Cherokee
Engine: 4.0
Originally Posted by NewJerseyXJ609
Does the top rad hose get hot? You might have a blockage or a bad water pump. My 95 loved to run hot in the summers. Finally I threw a water pump at it a couple weeks ago and all is well.
Member
Join Date: Dec 2009
Location: Ky
Posts: 151
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L
I have a bad stalling/shifting/high idle problem and I started out testing the tps. The volts seemed out of wack. So for gits and shiggles I tested the tps harness and I get the same readings. 5.07v constant on the outer wire, 4.88v - 5.07v increasing with throttle response, and 0.00v ground on inside wire. Shouldn't the middle wire start out muuuuch lower? Should I mention I dunked it a few weeks ago.
Thanks all.
Thanks all.
Last edited by donkeypunch; 12-05-2012 at 08:56 PM.
Herp Derp Jerp
Join Date: Nov 2011
Location: Parham, ON
Posts: 18,251
Likes: 0
Received 13 Likes
on
12 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L OBD-II
I have a bad stalling/shifting/high idle problem and I started out testing the tps. The volts seemed out of wack. So for gits and shiggles I tested the tps harness and I get the same readings. 5.07v constant on the outer wire, 4.88v - 5.07v increasing with throttle response, and 0.00v ground on inside wire. Shouldn't the middle wire start out muuuuch lower? Should I mention I dunked it a few weeks ago.
Thanks all.
Thanks all.
CF Veteran
Join Date: Sep 2011
Location: Frederick, MD
Posts: 10,447
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
Originally Posted by 87laredoxj
For those who did the kicker panel speaker mod what did you do with all the wiring down there?