my89xj

Thanks

a_shirey

Anytime broseph. Google is our friend.

jeeperscreepers92

Nvm i found the problem. There was a cut inthe insulation. tiny lil thing and it was resting against a ground in the fender just in the right way to have the bare copper touch it. I electrical taped it for now.

ScikoFaery

is it expensive? it just a rebuilt transmission put it in the fall

DESERTXJ206

You have some aort of exhaust leak. Most likely a cracked exhaust manifold. Thats very common with worn motor mounts. Mine does the same thing but is noticably louder in the engine bay. Ill be ording a factory replacment off ebay in 2 weeks.

donkeypunch

Not particularly. I think the kit for the 3 solenoids was around $130. But after you factor in a transmission pan gasket and tranny fluid and filter you are approaching $200. Plus your time.
They are simple to actually replace though, you will spend more time draining, removing/installing the pan then the actual solenoids. I replaced all three even though my torque converter one was the only bad one....I didn't want to go through dropping the pan again. But they do sell them individually if you decide to go that route. Good luck bud, pm me if you have any troubles.

joaopaulo

Hello...i would like to have help about gearbox and asking if anyone knows about a tutorial or video oe something about how to remove the jeep cherokee gearbox ...i know its not very easy but i guess its not so big deal like many people thinks and im readdy to trie but need little suport...take care all

hick92

Search YouTube there's quite a few how to videos on there

joaopaulo

im afraid there is not so many like that .. i alreaddy did that

Power73

does anyone know the torque specs from the upper and lower control arms? frame side and axle side? id appreciate any help. i found 85 ft lbs for all 4 lower bolts and for the uppers it looks like axle side-55 ft lbs frame side 66ft lbs. i would just like some confirmation to if those are right. thanks

87laredoxj

so my check antilock light keeps coming on in my 1990 laredo what is this saying? and how do i fix it?

DESERTXJ206

Are you trying to remove the steering gear box?

3 bolts on the driver side of the unibody
Disconnect upper drag link
Disconnect the input steering shaft
Remove the power steering lines going to it.

Not hard at all.

If you are reffering to the transmission,

Properly support vehicle, support trans. Remove drive shaft/s unbolt the 4 bolts on flywheel through the inspection plate. Remove shift linkage and sensor plugs. Loosen all the bolts and work its way out.

dukie564

Suspension Arm Upper
Front Nut . . . . . . . . . . . . . . . 74 N·m (55 ft. lbs.)
Rear Nut . . . . . . . . . . . . . . . . 89 N·m (66 ft. lbs.)
Suspension Arm Lower
Front Nut . . . . . . . . . . . . . . . 115 N·m (85 ft. lbs.)
Rear Nut . . . . . . . . . . . . . . . 115 N·m (85 ft. lbs.)

hick92

Have you used the search feature on the forum

joaopaulo

yes its the transmission cause im having problems and some noises when i drive in 1 and 3 velocity and sometimes they jump off , but the way you talk it seems its so easy but i imagine different and its something so heavy and large that i presume its not so easy like that ...or maybe it is and i thought it was more complicate....sorry the language but im portuguese