cruiser54

Pull the connector off the sending unit and see if there's oil in the plug/sender end.

ccooper1234

My check gauges also comes on at random times. I have no clue why.

ThatPurpleXJ

Probably 30-40 degree max. It even happened once on flat ground. Right after the first time it happened I checked the oil and it was completely full

cruiser54

Check the connector!!!

ThatPurpleXJ

Lol okay I'll be able to tomorrow but wouldn't that only relate to when I'm showing 0 psi? It's completely normal now

cruiser54

Why over think simple stuff that takes 22 seconds to check and verify?

Tylerzap

I dont think its the ignition. Might be though. Any other ideas before i tear apart my steering coloum?

straightsixjeep

I replaced mine because I was getting a squeeling at low speeds, either taking off from a stop or coming to a stop. It sounded similar to a belt squeel or a brake pad rubbing. I researched into it and they refer to it as "angry sparrows," which is what the centering ball assembly sounds like when its going out. If you have the $ it wouldnt hurt to pick up a new one since I hear if it goes bad on the road it can do a lot of damage. I replaced it with a spicer made centering ball assembly and the noise has gone away.

As far as u-joints, Im officially running all precision/moog parts. I used precision/moog for the front axle u-joints (replaced 2 wks ago), 3 of them for the front ds, and tonight I put 2 in my rear ds. I originally used Advance Auto's brand Brute Force u-joints which lasted a solid 5 months before they started to have a lot of play. Iv been having good luck with precision/moog so Il keep using them for now. If your looking for spicer, check with Napa. They are the only parts store near me that carries spicer.

sycoglitch

Thanks. My napa don't carry spicer. It's all good. I'm gonna take the dS out for now until I get the parts. I've had the parts list from quadretec for a lil now with center ball. March just hasn't been goo to me bill wise. Plus I'm doin the pinion seal at the same time for the from pumpkin. I don't usually look for the cheap way, but this month took me down. Ima do it right the first time like I preach to others.

Cherokeekid4x4

Happened again. Any ideas guys? My jeep will crank and crank but won't start. If I lay on the gas it'll start then die immedieatly. After laying on the gas for about a minute, it stayed on. Rough idle then it slowly started to get better. After driving it, it'll start back up. Has happened twice in the past 2 weeks. Can't be just a little thing lol. I have high idle when I put it in park if this has anything to do with it.. Someone suggested the IAC?

dukie564

TPS

Cherokeekid4x4

Alright ill fix it, thanks!

hick92

I was wondering what might cause a horrid knock that's present only at idle any rise of rpms and its non existent

I Leak Oil

That's what my flex plate sounded like when the bolts started backing out

hick92

I mean it sounds like it will grenade any second at idle

Edit also does high rpms cause them to loosen up