hick92

So this is a mj specific question I was wondering the point of the cab vents

Lowrange2

Styling. But it only matters if you can drive your MJ.

Do you need a header panel for that thing? I have one sitting in my yard... Where are you at, anyway?

cruiser54

To vent the cab. So that when you shut the door your eardrums don't hurt. And so the cab can vent with the HVAC system on. If you take off the inside trim, you'll see how it works.

DieselD

I'm pretty sure I've seen someone put a rearview mirror out of an s10 that had compass and temp I. Their XJ. I could find it googling. Stupid phone.

Anyways, if I was to do that. I think it would be possible to make a temp sensor for an overhead console work for temp.
But where do XJ overhead consoles get their compass info from?

dukie564

I have one from a caddy with that display waiting to go in also. Temp comes from a sensor behind the grille. Compass I believe is internal.

DieselD

Cool. I look in the Cadillacs too. Does it have map lights? That'd be cool to have on there.

I'd need the temp sensor from the caddy? Or a jeep?

donkeypunch

I've got a performance curve high-flo spun catalyic converter and a flowmaster44. It has a nice deep tone when just tooling around, and a loud roar when I give her WOT. Actually sounds pretty damn mean when climbing or mudding, ie. low RPM's. I've been asked before if I have cam'd it out because of the tone.
I'm sure my machined throttle body, headers and cowl intake have contributed to some of the sound; but a fellow jeeper friend of mine has just the flomaster44 and it has a good throaty tone by itself. Youtube has a bunch of different videos of setups that helped me make my decision. One word of advice, your exhaust will sound louder inside the cab than outside. So make sure your stereo works good

94xjohio

Donkey punch lol., what a name

bammorelli

Need help with my 96 jeep Cherokee sport. The auto trans pops out of gear while I am on the highway. I pull over get to a stop, and then it works again. also, sometimes the tranny will only shift if I manually shift then it will work again. I have fluid and have adjusted the kick down. the tranny is about a year old. need help as I do not want to buy a new car

hick92

Actually lowrange I have the front clip parts in the car port just letting the ground dry out a bit

xj_maniac_newb

Or just ride in a mid 90's model chevy pickup. We had one as a work truck and besides the hinges failing every month or two, if you slammed the door without one of the windows down you were in for some sore ears.

Celticclove

Ok bros can any one tell me or give me a diagram for the transfer case brace ?? I'm building my owe skid/brace I need the dementions of the holes that will hold it up .. Ie center to center of the holes on how far apart they are next to each other and from one side of the jeep to the other side thanks

XJ=mistress

So i over heated transmission on my 98 classic helping a Friend tow a trailer for about a four hour drive. It basically started leaking from every were Oil pan, in between the bell housing and spaying all over the under side of the jeep.
I went and grabbed some trans fix and put a bottle and it stopped leaking for a few days. Now its leaking from inside the bell housing again. Im taking it into a transmission shop on Thursday is there anything i should look at before i take it in ?
I really don't wanna get raped by the shop.
Im guessing it the seals how much work is it to do my self

xj_maniac_newb

You should look for another trans on craigslist. No telling how much that damn shop is gonna charge you.

XJ=mistress

I have two other transmissions
But one is off a 93 and the other is off a 87
Would either of them bolt up with out issue or am i going to be running into wires not matching up