Yet another lack of heat post
#31
Newbie
I used a dremel and cut a hole in the heater duct for access. Used a flashlight to inspect and was opening and closing properly. Duct taped the piece back on. Go on heater treater website and they have pics where to cut
#33
Newbie
Yup nice and tight no bends. I'm at a loss I've done everything and still luke warm at best. I don't want to do heater core but I might have to it's pretty cold here in nh. Good luck hope you get your heat!
#35
Junior Member
Thread Starter
Join Date: Sep 2017
Location: Central NJ
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
I cut out a notch for the blend door and looked around inside as best as I could. Nothing out of the ordinary. Blend door is in fine shape and the axle it pivots on was not broken. Full sweep from hot to cold. The actuator motor works smoothly and also moves the full sweep. I taped the notch back in place. No time to test drive it.
#36
Member
Join Date: Oct 2017
Location: New Mexico
Posts: 227
Likes: 0
Received 10 Likes
on
8 Posts
Year: 1998
Model: Cherokee(XJ)
Engine: 4.0 L I6
If you are considering replacing your heater core, I am in the middle of mine and can give you tons of tips on taking it out (and putting it in once I do it this weekend). I also found a really helpful guide for it that I can PM. It is not a very hard job, especially with 2 people, it just takes a long time.
#37
Junior Member
Thread Starter
Join Date: Sep 2017
Location: Central NJ
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
Update.
I got to drive the Cherokee today. 28-35 degrees and windy as all get out. Heater is now blowing almost hot! Nowhere near as hot as my first Cherokee would blow, but hot enough that I didn't need to wear gloves and a jacket while driving! I'll take it!
All I did was remove the blend door actuator, cut open the heater plenum above the actuator, flap the door back and forth, turn the key on, turn the heater control to where the red and blue meet, watch the actuator till it got to the middle of it's sweep and turn the key off, reinstall the piece I had cut out, Duct tape it in place, align the blend door with the actuator and bolt the actuator back in place. Turn the key on, move heat control to full hot and go for a drive.
I hope this helps anyone who seems to have heat/blend door issues.
Ken R
I got to drive the Cherokee today. 28-35 degrees and windy as all get out. Heater is now blowing almost hot! Nowhere near as hot as my first Cherokee would blow, but hot enough that I didn't need to wear gloves and a jacket while driving! I'll take it!
All I did was remove the blend door actuator, cut open the heater plenum above the actuator, flap the door back and forth, turn the key on, turn the heater control to where the red and blue meet, watch the actuator till it got to the middle of it's sweep and turn the key off, reinstall the piece I had cut out, Duct tape it in place, align the blend door with the actuator and bolt the actuator back in place. Turn the key on, move heat control to full hot and go for a drive.
I hope this helps anyone who seems to have heat/blend door issues.
Ken R