hbracing13

Who what's to go to the jy right meow?

87XJBazooka

So im thinking of pulling the engine in my 90 amd doing a nice refresh, what parts can I change to make the 90 compatible with some 91+ upgrades including intake set ups and exhaust manifolds?

And does anyone have a 97+ front clip by any chance?

Monster, do you still have the clutch and flywheel?

cruiser54

Use the 91 and later exhaust manifold. New headpipe will be needed because of routing and the O2 sensor will then mount there. Have one made without the factory "crush".

Monster3663

I still have it and I have a 91+ intake with a modified TPS on it already. I was going to use it before I started my swap. With that and a new exhaust from a 91+ and a new down pipe should be it. I would also go to youpullit and get the engine brace from a 96 plus and install it too.

87XJBazooka

Would an exhaust shop do this or can I buy it made? Is there a write up on this somewherem

87XJBazooka

I can take that stuff off your hands then. Did you sell the front clip?

Monster3663

Front clip is gone.

cruiser54

I have the local shop bend them up for me, nice and tight to the engine and trans and clears the driveshaft well. Grab that manifold from Monster if it trips your switch. Having the TPS mod already done is a huge plus.

87XJBazooka

Heard. Ill take the other two things then. Hell, what else you got?

87XJBazooka

Would this set up do well with a cowl induction and cat back exhaust?

cruiser54

The manifold and the downpipe are an improvement no matter what you do. Stock to modified.

87XJBazooka

Sweet. I feel like a total noob. Thank God for beer and hard rock radio stations in my garage.

Monster3663

You know where the parts are let me know when you want to come up?

Monster3663

Hey Guys and JRock check out how this came out. 1998 dash and center console in my 1990. It was a PITA but worth it I think.

morningstretch87

soooo jealous wish I had the time and patience to do it....