New Mexico Roll Call.
11-22-2013, 04:23 PM
#9288
Senior Member
Join Date: Sep 2013
Location: Los Lunas, NM
Posts: 706
Likes: 0
Received 5 Likes
on
4 Posts
Year: 1996
Model: Cherokee
Engine: Straight six
im gonna trim the fenders so that should help a bit, plus the bumpstops, should be in good shape. Did you cut and fold or did you put a rubber trim on after you trimmed yours?
11-22-2013, 04:34 PM
#9289
CF Veteran
Join Date: Sep 2013
Location: Albuquerque, NM
Posts: 2,820
Likes: 0
Received 4 Likes
on
4 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
Trimmed the front, and cut and fold the rear. You have to cut and fold the rear or you'll cut off the spot welds and expose the interior. Up front I havent done any trim but I plan to bed line the wheel wells and the bottom part
Last edited by PurpleToxin505; 11-22-2013 at 04:39 PM.
11-22-2013, 08:10 PM
#9290
CF Veteran
Join Date: Sep 2013
Location: Eaton Co
Posts: 1,922
Likes: 0
Received 1 Like
on
1 Post
Year: 2001
Model: Cherokee
Engine: 4.0
Found this guy that builds custom Jeep DS. He has a good reputation and they are stronger and also cheaper than rebuilding the stock shaft. $260.00 shipped.
11-22-2013, 10:01 PM
#9293
Senior Member
Join Date: Sep 2013
Location: Los Lunas, NM
Posts: 706
Likes: 0
Received 5 Likes
on
4 Posts
Year: 1996
Model: Cherokee
Engine: Straight six
ya i have a garage on my shop but no heating on the garage side prolly take out a lil floor heater, then start the wood stove in my shop