Northern Utah BS thread
#2854
CF Veteran
Thread Starter
Join Date: Sep 2009
Location: West Valley
Posts: 3,612
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee (XJ)
Engine: 4.0
#2855
Senior Member
Join Date: Nov 2009
Location: SLC Utah
Posts: 842
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: I6
ok sounds good, that guy that helped you with your bumper, is he good at welding if so i might need to see if he could weld my unibody where the box is tearing
#2857
CF Veteran
Join Date: Aug 2009
Location: Herriman, Utah
Posts: 1,534
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Cherokee
Engine: 4.0
You don't just weld the unibody. You need to plate it, get a steering box brace, and a track bar bracket brace. Buy or build them. Trust me, i've been down this road already with mine. And still fighting it.
#2861
CF Veteran
Join Date: Aug 2009
Location: Herriman, Utah
Posts: 1,534
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Cherokee
Engine: 4.0
You should build a brace from the track bar bracket and tie it into the passenger side like i just did.
Big lift and 35's = very unhappy uni-body Mike. get used to it.
Last edited by X1994J; 10-10-2010 at 06:10 PM.
#2863
CF Veteran
Join Date: Aug 2010
Location: Huricane, Utah
Posts: 1,326
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994 Ford Bronco
Model: Cherokee
Engine: 351 W
#2864
CF Veteran
Join Date: Aug 2010
Location: Huricane, Utah
Posts: 1,326
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994 Ford Bronco
Model: Cherokee
Engine: 351 W
Hey X1994J how much to make me the tcase linkage like yours? After looking it over jeeps setup is a scabby POS!