Gorillaxj

I need some recovery points welded onto my bumper, Just two D-ring tabs. The welder I am using Will not penetrate them as there 1" thick. Anyone able to do me a favor? beer/money involved of course...

I haven't tried they are clean, I just know the 140amp miller I have to use Won't do the job....

dev_daddy

So... Check this out. I tore down my tcase today to put my SYE on. My transfercase has always made a hideous sound when i put it in four wheel drive. But i've always just ignored it. Well... I now know what it was! First off, in the bottom, my little magnet is just caked with stuff. it's double the size it should be. Next thing i find stuck to it is the little keepers that go in the synchronizer hub assembly. Along with little chunks of whatever else... Sweet! And the chain binds up on the sprockets really bad. So basically installing my SYE turned into a whole new case rebuild. Awesome...

Gorillaxj

OUCH! that sucks... better fixed now then a problem later...

X1994J

Come on over...

X1994J

FUUUUUU....... just find a used one or can you replace all the parts pretty cheap?

dev_daddy

cheapest used one i can find is 350! But i just bought a new chain, mode fork pads, and the synchro spring that got mangled up, for 88 bucks! Now just the wait in the mail >

dev_daddy

Agreed haha

Gorillaxj

That would be awsome! When works for you? I work until 6 most days. want some beer or?

X1994J

I think tomorrow or thursday night after 6:30 would work, i'll check and let you know for sure.

X1994J

Thursday works if you want to plan on it.

92xj92

GUESS WHO!!!!!!!!!!!!!!!

Gorillaxj

sure. that works. Just to be clear, thr D-ring tabs are 1" thick, and its a 3/16" bumper... just want to make sure your comfortable with that. want some beer??

dev_daddy

No ones guessing haha

up_yours_7

Picked up a new axle for my car for a sweet deal can't wait to get it in and roast some tire haha

builtnotbought89'

Dont tell me chandler bought a XJ...

Who???