Maryland Cherokee Club
11-06-2011, 06:07 PM
#2193
Senior Member
Join Date: Dec 2010
Location: Linthicum, Md
Posts: 903
Likes: 0
Received 1 Like
on
1 Post
Year: 1987
Model: Cherokee
Engine: 1987 4.0L (242 CID) I6 RENIX FI 242 173 hp (129 kW) @ 4600 rpm, 224 lb•ft (304 N-m) @ 4000RPM
Just tape some card board in there, he'll be fine
11-06-2011, 06:12 PM
#2196
☠ CF Sheriff ☠
don't laugh...my drivers side floor currently consists of....
pieces of last years halloween costume, held down with self tapping screws and bathroom caulk. I was the Tinman, and made a costume out of 22 gage stainless duct metal i found at Lowes.
This is my issue (see the leaf?)
pieces of last years halloween costume, held down with self tapping screws and bathroom caulk. I was the Tinman, and made a costume out of 22 gage stainless duct metal i found at Lowes.
This is my issue (see the leaf?)
11-06-2011, 06:14 PM
#2198
Moderator of Jeeps
Join Date: Jul 2011
Location: Frederick, MD from Cleveland, OH
Posts: 21,029
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1993 YJ Wrangler
Engine: 4.0 I6
I was just gonna caulk it til I can get it done, but if it'll only be a week or two, I may just yank the carpet and put the rubber floor mat back down
11-06-2011, 06:17 PM
#2199
CF Veteran
Join Date: Jul 2011
Location: Elkton, Maryland
Posts: 3,235
Likes: 0
Received 2 Likes
on
1 Post
Year: 1998
Model: Grand Cherokee
Engine: 4.0
don't laugh...my drivers side floor currently consists of....
pieces of last years halloween costume, held down with self tapping screws and bathroom caulk. I was the Tinman, and made a costume out of 22 gage stainless duct metal i found at Lowes.
This is my issue (see the leaf?)
pieces of last years halloween costume, held down with self tapping screws and bathroom caulk. I was the Tinman, and made a costume out of 22 gage stainless duct metal i found at Lowes.
This is my issue (see the leaf?)
11-06-2011, 06:18 PM
#2200
Senior Member
Join Date: Dec 2010
Location: Linthicum, Md
Posts: 903
Likes: 0
Received 1 Like
on
1 Post
Year: 1987
Model: Cherokee
Engine: 1987 4.0L (242 CID) I6 RENIX FI 242 173 hp (129 kW) @ 4600 rpm, 224 lb•ft (304 N-m) @ 4000RPM
Ok, I will totally volunteer my time and skills for you at this point.
11-06-2011, 06:19 PM
#2201
CF Veteran
Join Date: Jul 2011
Location: Elkton, Maryland
Posts: 3,235
Likes: 0
Received 2 Likes
on
1 Post
Year: 1998
Model: Grand Cherokee
Engine: 4.0
Duct Tape it until we can get a new piece of metal in there...
11-06-2011, 06:19 PM
#2202
☠ CF Sheriff ☠
That's the plan. Full new pans are like $130 each, that has to wait though...
