Voted for ya. Where did you get that hitch table thing?

 

Here's to equal campaigning, I kept it to just my build thread...

Either way I've always followed SteveMongr's Build. Really shows how different the wheeling is on the other end of NC

 

lol nothing like some healthy competition

 

Oops, I got busted. Did not realize at the time it was only in your build thread!
Watch out for this local PA thread, they do not take kindly to 'outsiders' like us. rofl

Just a piece of plywood, carpet on one side, vinyl on the other. It cantilevers off the bumper (Nates4x4) where there is a gap between the bumper and underside of cargo floor. That gap has been useful, for the table and reverse lights.

 

Who can tell me where the hell these plugs go?


This one is right under the steering column, but I can't find anywhere for it to plug in on the column.


These two come through the firewall right behind the intake manifold and run along the trans tunnel

 

was it ever used for police use?

 

Not that I know of. Harness came from a bone stock 93 XJ. Can't remember if they were plugged into anything in the donor or not

 

Got the MJ running last night! Annnnndd the water pump is seized up

 

Those are for the flux capacitor. The first one is for the plutonium gauge sending unit and the second one goes to the flux capacitor itself

 

I was thinking the one was supposed to go to the headlight fluid sensor. But in reality they seem to have no purpose. Jeep runs fine without them

 

*cricket*









.....my bender gets delivered tomorrow. I'm excited.......even though I have no tube yet.

 

thats sweet, your gunna sit in the garage all day and stare at it while drinking some shine/yuengling thinking about ll the crazy unnecessary things you can make for the jeep with it haha

 

Yea, while wishing I had money for tube..... Lol

 

If u didn't spend so much on the bender. U could have afforded o buy tube. Lol

 

But then I wouldn't be able to bend it