Project Danger Cart
04-03-2014, 02:05 PM
#961
☠ CF Sheriff ☠
Thread Starter
how did you know my pecker was small enough to fit in that tube?
04-04-2014, 08:45 AM
#963
☠ CF Sheriff ☠
Thread Starter
Old and Busted:
New Hotness:
One Side Done - Bling +5. Other side will get done tonight or tomorrow.
Repainted the 5150s. I left the Bilstein sticker in place even though it looks like poo. Came out pretty good! New bushings get pressed in tonight.
New Hotness:
One Side Done - Bling +5. Other side will get done tonight or tomorrow.
Repainted the 5150s. I left the Bilstein sticker in place even though it looks like poo. Came out pretty good! New bushings get pressed in tonight.
Last edited by dukie564; 04-04-2014 at 10:30 AM.
04-05-2014, 06:18 AM
#966
No, I don't lick fish.
problem solved. Picked up one of these
Attachment 237434
Attachment 237434
Last edited by Basslicks; 04-05-2014 at 06:30 AM.
04-05-2014, 06:26 AM
#967
No, I don't lick fish.
Old and Busted:
Attachment 237569
New Hotness:
Attachment 237570
One Side Done - Bling +5. Other side will get done tonight or tomorrow.
Attachment 237571
Repainted the 5150s. I left the Bilstein sticker in place even though it looks like poo. Came out pretty good! New bushings get pressed in tonight.
Attachment 237572
Attachment 237569
New Hotness:
Attachment 237570
One Side Done - Bling +5. Other side will get done tonight or tomorrow.
Attachment 237571
Repainted the 5150s. I left the Bilstein sticker in place even though it looks like poo. Came out pretty good! New bushings get pressed in tonight.
Attachment 237572
04-08-2014, 02:43 PM
#968
☠ CF Sheriff ☠
Thread Starter
04-08-2014, 02:47 PM
#969
☠ CF Sheriff ☠
Thread Starter
In other news...
One step forward, two steps back. Cut a hole in my new floor pan to access the TC crossmember bolt i broke off replacing the transmission mount a few months ago. Removed the nut and plate, and welded a new nut to a piece of 3/16 plate and welded it into the frame rail. Now i have 4 bolts holding up my driveline again!
And i got the other side replaced. This should illustrate the problem quite well.
Shiny!
One step forward, two steps back. Cut a hole in my new floor pan to access the TC crossmember bolt i broke off replacing the transmission mount a few months ago. Removed the nut and plate, and welded a new nut to a piece of 3/16 plate and welded it into the frame rail. Now i have 4 bolts holding up my driveline again!
And i got the other side replaced. This should illustrate the problem quite well.
Shiny!
04-08-2014, 02:52 PM
#970
☠ CF Sheriff ☠
Thread Starter
Another update!
Iron Rock Front Lower BPEs just got delivered! I also got my new bushings pressed into the 5150s last week so now i can install them.
Iron Rock Front Lower BPEs just got delivered! I also got my new bushings pressed into the 5150s last week so now i can install them.
04-09-2014, 10:25 AM
#974
☠ CF Sheriff ☠
Thread Starter
yea...KY? not likely. I plan on going to NAC-Fest up in PA.