Project Danger Cart
#1278
☠ CF Sheriff ☠
Thread Starter
far more likely to involve beer or whisky when it happens lol
#1279
☠ CF Sheriff ☠
Thread Starter
not much to update, it's been too damn cold to work on anything.
We got some decent snow here yesterday though (6-7" in just over 8 hours). I'm so glad i put the front driveshaft back in last week...the roads were absolutely awful
"Snow Emergency Route" (Completely unplowed)
We got some decent snow here yesterday though (6-7" in just over 8 hours). I'm so glad i put the front driveshaft back in last week...the roads were absolutely awful
"Snow Emergency Route" (Completely unplowed)
Last edited by dukie564; 03-06-2015 at 12:14 PM.
#1281
No, I don't lick fish.
#1282
☠ CF Sheriff ☠
Thread Starter
Picked up a purchase for the XJ - plans are changing a bit. I was going to convert my a/c compressor for on-board air this spring, but couldn't pass this up.
Vlair 480c Compressor
150/110 psi solenoid
Gauge
2.5 gal tank
I'm debating remounting it to a board like it is now, or a permanent install. I think i may go permanent eventually so i can use it for air horns and lockers in the future as well.
Vlair 480c Compressor
150/110 psi solenoid
Gauge
2.5 gal tank
I'm debating remounting it to a board like it is now, or a permanent install. I think i may go permanent eventually so i can use it for air horns and lockers in the future as well.
#1284
☠ CF Sheriff ☠
Thread Starter
everything is on hold until after my Professional Engineering licensure test is complete (middle of April).
Short term plans in the works for Spring:\
Doorless mod (front doors) (with soft doors?)
Monstaline the interior [have kit]
TC Linkage mod [have parts]
Exhaust Manifold Replacement and tailpipe repair [have parts]
Finish replacing rear drum brake pads and piston [have parts]
2x6 Rocker Replacement Sliders
Replace H.P. Steering line and install WJ pump [have pump]
Install BJs in spare HP30, install into truck w/ new UCAs [have parts except BJs]
Short term plans in the works for Spring:\
Doorless mod (front doors) (with soft doors?)
Monstaline the interior [have kit]
TC Linkage mod [have parts]
Exhaust Manifold Replacement and tailpipe repair [have parts]
Finish replacing rear drum brake pads and piston [have parts]
2x6 Rocker Replacement Sliders
Replace H.P. Steering line and install WJ pump [have pump]
Install BJs in spare HP30, install into truck w/ new UCAs [have parts except BJs]
#1286
CF Veteran
Join Date: Jan 2012
Location: Baltimore, MD
Posts: 8,272
Likes: 0
Received 1 Like
on
1 Post
Year: 1999
Model: Cherokee
Engine: 4.0 I6 HO
everything is on hold until after my Professional Engineering licensure test is complete (middle of April). Short term plans in the works for Spring:\ Doorless mod (front doors) (with soft doors?) Monstaline the interior [have kit] TC Linkage mod [have parts] Exhaust Manifold Replacement and tailpipe repair [have parts] Finish replacing rear drum brake pads and piston [have parts] 2x6 Rocker Replacement Sliders Replace H.P. Steering line and install WJ pump [have pump] Install BJs in spare HP30, install into truck w/ new UCAs [have parts except BJs]
You should do a write-up on the slider install. I'm looking to do it this summer as well.
Or at least take a bunch of pictures and post them. Lol.
#1288
☠ CF Sheriff ☠
Thread Starter
also, the wife got me an awesome birthday present. Just need to figure out how/where to mount them...the small one fits fine, but the big one is HUGE. I want to mount them to the passenger side of the engine, but to fit the big one i need to remove the a/c compressor