JKing71

I'm trying to install '99 leather WJ seats into my 2004 WJ. The original passenger seat did not come with power controls. The new seat does have power controls. I found this wiring harness under the carpet of my 2004 WJ that plugs right into the replacement seat from the '99 WJ. However, the pins don't line up with the ground and power wires in the new replacement seat (pin 2 is ground, pin 3 is power). I was able to confirm with my power probe that the seat motor functions do work. Can anyone ID the four wires in the harness on the body side (see pics)?

Ralph77

I remember researching about putting power/heated seats in my '00 XJ coming across a website about WJ's.
Now since it did not apply I did not pay too much attention to it.
But at a glance it looked pretty thorough.
So I can't seem to find it now but thinking this might be it but they changed the look.
So maybe this will help.

https://jeepspecs.com/wj-generation/...-heated-seats/

Zeexeez

I have same problem did you figure it out?

JKing71

Yes, I did. I was able to get another connector from a donor WJ that had the ground and hot lead on it (in the blank locations on the harness on the picture) and splice into them. I did a fuse tap into the fuse box above the driver knee area with a 30 or 50 amp fuse (which ever is the appropriate one) and then ran the ground under the carpet and affixed it to where I found other grounds.