Wobble, wobble and we all fall down!
#16
Old fart with a wrench
You know the old saying, "There's more than one way to skin a cat?" My question is who would want to skin a cat, unless it was a big wild one?
Your pics remind me of when I changed the clutch on my Volks Beetle. I used two concrete blocks and a 4x4. I had to use a bottle jack to put it back in, though.
I remember getting a rear axle from a Pick & Pull. We had to disconnect everything and then pay $25 for them to pick the back end of the jeep up with a forklift so we could drag it out. Later I was told we got lucky because normally, it costs $100 and they do all the work.
BTW, when I did my Chevy truck's transmission, I built a cradle to bolt on my floor jack out of a steel plate and 4 pieces of threaded rod to rest the t/case on. The shape and weight of the t/case is so difficult to handle because of the front drive section, I couldn't possibly do it by hand. I had to use an old seatbelt to keep it on the cradle and be careful because it wanted to flip over until I realized I had to roll it in sideways, perpendicular to the truck's centerline. I was also working alone because my friends abandoned me. I guess they didn't want to lay on their backs on a gravel driveway any more than I did. Oh well. I did lay down some 3/4 plywood to work on, however.
Your pics remind me of when I changed the clutch on my Volks Beetle. I used two concrete blocks and a 4x4. I had to use a bottle jack to put it back in, though.
I remember getting a rear axle from a Pick & Pull. We had to disconnect everything and then pay $25 for them to pick the back end of the jeep up with a forklift so we could drag it out. Later I was told we got lucky because normally, it costs $100 and they do all the work.
BTW, when I did my Chevy truck's transmission, I built a cradle to bolt on my floor jack out of a steel plate and 4 pieces of threaded rod to rest the t/case on. The shape and weight of the t/case is so difficult to handle because of the front drive section, I couldn't possibly do it by hand. I had to use an old seatbelt to keep it on the cradle and be careful because it wanted to flip over until I realized I had to roll it in sideways, perpendicular to the truck's centerline. I was also working alone because my friends abandoned me. I guess they didn't want to lay on their backs on a gravel driveway any more than I did. Oh well. I did lay down some 3/4 plywood to work on, however.
Last edited by dave1123; 03-16-2014 at 06:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post
407rotorhead
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
06-07-2023 02:44 AM
Mike Canada McDonald
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
09-30-2015 07:48 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)