WARR-WAGON/ tow rig
09-03-2009, 11:25 AM
#34
Senior Member
Join Date: Feb 2009
Location: Roswell, NM
Posts: 850
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0 L
Me and a buddy are looking to get our hands on a 88 Ram Charger for really cheap...Where did you find the parts for your truck at?
09-03-2009, 02:30 PM
#35
Senior Member
Thread Starter
I got just about everything from schucks/o'reillys
Yesterday while waiting for an 02 landrover to show up at the shop to do bumpers on it, I did some trimming of sheetmetal on the bed. Progress will have to wait now till I finish this rover.
Yesterday while waiting for an 02 landrover to show up at the shop to do bumpers on it, I did some trimming of sheetmetal on the bed. Progress will have to wait now till I finish this rover.
09-05-2009, 10:39 PM
#38
CF Veteran
Join Date: Aug 2008
Location: Hollidaysburg, PA
Posts: 5,603
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0 lt. 242 cu.in.
09-06-2009, 07:53 PM
#40
Senior Member
Thread Starter
well i actually worked on my own rig today lol
cut cut here and cut cut there
i still need to clean it up a bit and i know i cut it up higher than the back of the bed floor but i will be tucking the bumper up nice and tight.
while cutting the bed side, the rear of the bed side seperated from the inside of the bed. bad pic
here you can see where the bed sides must have seperated before, there was some bad welds there. i will be cleaning the area up and re-welding it befpore im done.
and going back together
cut cut here and cut cut there
i still need to clean it up a bit and i know i cut it up higher than the back of the bed floor but i will be tucking the bumper up nice and tight.
while cutting the bed side, the rear of the bed side seperated from the inside of the bed. bad pic
here you can see where the bed sides must have seperated before, there was some bad welds there. i will be cleaning the area up and re-welding it befpore im done.
and going back together
12-04-2009, 11:55 PM
#43
Senior Member
Thread Starter
Its still sittin in the shop, I've just been busy with hunting and holidays. I went to put the radiator in and this truck doesn't have a "true 80" core support so the mounts didn't line up. My new radiator came in today so this weekend I should have some progress, but then again I may be getting ANOTHER cherokee tomorrow so who knows lol.
