Floor pan seat reinforcement
#1
Member
Thread Starter
Join Date: Oct 2015
Location: long island nass
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
Year: 99
Model: Cherokee
Floor pan seat reinforcement
Hey i was wondering if anyon sells them, i called a couple places and i cant find any, he is a pic of mine
#7
CF Veteran
Originally Posted by nujeepguy;3324295[B
]welding would not allow using seam sealer[/B],very tough stuff and keeps all overlapping metal protected. everything is bolted to frame and screwed to side metal. if it ever needs work it can be redone, although the seam sealer would be tough to remove. it probably would hold it all together!!
all metal mtreated with rust bullet top and bottom,sealed 100%.
ill report back later!!
oh, no fires from torch!
all metal mtreated with rust bullet top and bottom,sealed 100%.
ill report back later!!
oh, no fires from torch!
To the OP, my seat brackets were much like yours. I just patched and welded them with some sheet metal, and they have been working fine. If they are too far gone, you can always make them from scratch. They aren't too complicated.
Trending Topics
#9
CF Veteran
Join Date: Jun 2011
Location: Louisville,KY
Posts: 8,014
Likes: 0
Received 16 Likes
on
16 Posts
Model: Cherokee
Th floor pan is structural it has to be welded in.Seam sealer is just that a sealer for seams in metal not a panel adhesive or any kinda glue.Seam sealer is put over seams that have been welded to make sure they are 100% water tight.
#12
CF Veteran
Join Date: Jun 2011
Location: Louisville,KY
Posts: 8,014
Likes: 0
Received 16 Likes
on
16 Posts
Model: Cherokee
Put a rusted out floor jeep on a frame table,I bet its not where near straight it might look it but a frame table never lies.Theres 2 reasons they rust out easy,The lack of any kinda factory under coating and water leaking it from either the doors or windshield collects in the floors the carpet stays wet and rust starts to grow and grow.Any bare metal will rust even a weld thats why you should paint over any bare metal.
#13
Banned
Join Date: Oct 2016
Posts: 1,553
Likes: 0
Received 4 Likes
on
4 Posts
Year: 2000 and 1998
Model: Cherokee
Engine: 4.0
Put a rusted out floor jeep on a frame table,I bet its not where near straight it might look it but a frame table never lies.Theres 2 reasons they rust out easy,The lack of any kinda factory under coating and water leaking it from either the doors or windshield collects in the floors the carpet stays wet and rust starts to grow and grow.Any bare metal will rust even a weld thats why you should paint over any bare metal.
Last edited by nujeepguy; 04-22-2017 at 11:18 AM.