Put on my spare. Picked up a screw somewhere while camping over the weekend.

 

Lets try this again sound bar 2.0 is installed and the twisted front bumper is off, now to figure out how/when im gonna get this other one on, and what im going to do with this black cannister??

The last one is just for fun... TWINNING!!!

 

Just relocate to the hood compartment. That's what most ppl do.

 

X2 put it by your distributor, that's where mine is

 

I took mine out along with the cruise control. I am not sure that would fly on your 95, I think they have a vacuum powered fuel pressure regulator.

 

got her stuck in a gas station parking lot stoopid flooded out parking

 

You had to know it was kinda soft right? It looks like it from here. I would have loved that. Hammer down and make a mess.

 

And thats what she said!

 

Started at about noon and was done at about 8 (about 2 hours was spent going to two different AdvanceAuto for the hub assemblies and Sears to replace some broken tools). My buddies torches and a ball joint press made the job go quick. I also spent a good amount of time with a die grinder w/ wire wheel on the knuckles and calipers before I painted everything with black caliper paint (good to 500 degrees).

One of the rotors that I got ended up being defective. When I tightened the lugs it would freeze the wheel like the breaks were depressed. I just slapped the old rotor on until I can get back to Advance for a new one.

By the way, the ball joints were causing the front end to wander / swerve a bit when I would let off gas. I thought it was the gear box or the brakes but the ball joints solved the problem.

 

Ball joints suck! It definitely goes much better with two people and beers. I can't imagine how long it would have taken without torches and a ball joint press... And my buddy who's an expert backyard mechanic.

 

headed to the pick and pull for some goodies , hope they have what I need

 

hockey puck bumpstops are finally in

 

Installed my new (to me) 97-01 fuel rail that I got at the junkyard, brought back down to bare metal, and repainted with duplicolor metalcast.


I was gonna do the neon injector swap but the injectors weren't long enough to reach the holes in the intake manifold.... Any ideas on how to make them fit?

 

Installed my new (to me) 97-01 fuel rail that I got at the junkyard, brought back down to bare metal, and repainted with duplicolor metalcast.

I was gonna do the neon injector swap but the injectors weren't long enough to reach the holes in the intake manifold.... Any ideas on how to make them fit?

 

knew it was soft just wasnt expecting the drop off was hope'n for more spray less stuck