cleaned and replaced the vent tube on my xfer case. it was clogged ultimately causing the output shaft seal to leak. also replaced the vent tube on my front dif as it tangled w a u joint in the front...and lost.

 

ugh, I had to pull my wheel to tighten a loose bolt yesterday, It took so long to get it back together, kept dropping parts and not realizing it.

 

Nice shots I'm digging that push bar and skid plate.

 

I did the same! But I had to move mine back a few inches because I'm 6'4 and my head hit it

 

Lol thats why I havent put one up front in mine. Sucks being tall lol

 

Yeah it sucks! Haha just move it a few inches behind the dome light and make a small bracket and glue it to the roof and you'll be fine! Lol

 

Cool thanks for the tip. May do that to my rear sound bar its just hanging there with no support. Sadly nothing to support it in the back of my 89'

 

Yea it is. Turn signal switches actually come out easy too. I've had to do enough that I just bought my own puller.

 

Tightened up all my exhaust and intake manifold bolts

New oxygen sensor installed,new coil in aswell.

Was a good day,and she runs like a beast!

Once I get my balljoints and muffler done with I'll be satisfied and will start saving for longarm's.


Its been getting consistently better running since I got It,and I bought it about a year ago

 

Cleaned out the inside of my XJ today, took the doors off, and went for a drive. Threw a 12" subwoofer in it too, hooked up to my Kicker ZX200.2 amp, and hooked the 6x9's straight to the head unit (they were run off the amp before I put the subwoofer in).

 

Pulled my Jeep up to the garage to weld up an exhaust leak, and the water pump blew out. So I replaced the O2 senor, clutch fan, water pump and welded the exhaust back together. Got to love when this crap happens, but at least it's all fixed and much quieter!

 

so much fun right! Haha

 

Replaced fuel injectors with reman. Bosch 4-hole injectors! My first real repair ever done on my own!

 

New windshield put in and switch my black out tail lights to the normal one to pass inspection

 

Installed a new catalytic converter and Spectre cowl intake. My muffler is in my back seat at the moment because I had to cut off some of the pipe with the old rusted cat still stuck in it, which didn't leave enough room to clamp around the new cat converter. Gotta get it welded on later this week.

The jeep sounds so badass now with the new intake and no muffler. Was seriously considering straight piping it haha.