Put Rugged Ridge shorty headers on today, sprayed throttle body with seafoam, & replaced PCV valve I broke think that's correct its a plastic 90/elbow on top of valve cover towards the back. I got new one from dealer $6 & change. Also cleaned valve covers off. Next I need to replace down pipe with O2 sesnor in it. I dented it pretty bad wheelin over dunes on the beach dent size is big enough to fit a 1/4 of a tennis ball in it front driveshaft hit, need new bumpstops too but waitin for lift.

 

installed all 8 nylon nuts on the 4-link....reattached vent hose to rear diff. welded bolt to truss for brake line block. rerouted brake lines. started new exhaust routing. installed coil bucket retainers. Been busy don't ya think? ALMOST DONE.

 

I relocated the vacuum pod from under the bumper to under my air filter. Also I changed the rear seal on my transfer case and aft u-joint on the rear shaft.

I have a DEATH WOBBLE issue to clear up then I am ready to hit the trails.

 

Just watched to odometer roll past 300,000 kilometres (186,700 miles). Planning for 3" lift and paint job this summer.

 

build thread?

 

installed aFE intake this morning before class. didn't think it'd make that big of a difference until i saved enough for a bored throttle body, but damn it took off like a bat out of hell.

 

bolted on the new rims and tires
30x9.5 tires and rims

 

Just realized there's two of these threads.,

Changed my oil and spark plugs, didn't really need it but it was nice out.

 

got my tires ballanced. finally no DW!!!!!!!!!!!!!

 

Finishing up Control arm Drop bracket install.. Then Im pulling the diff cover to try and find my crazy clunk..

 

tightend up my ubolts cuz for some reason they were crazy loose

 

Finished up exhaust, put on the tires and flexed it out on the fender of my hauler.....Everything is great! Now I just have to order a couple of Limiting Straps and I'. off to Moutainside.....wooohoooo..

 

put in a new t-case, new ignition, cussed at it, drove it home.

 

I decided to keep the old girl so I fixed the passenger side seatbelt reciever so when my wife (old girl) sits shotgun she doesn't go threw the window if somethin were to happen. Old 1 just released when it wanted to. Picked up reciever at Condons junkyard for $35 bit pricey but I had my daughter with me had to go somewhere they pull for you she's only 3 & need to be 16 to enter yard.

 

Oil change and a new dist cap.. no more check engine for misfires