What did you do to your Cherokee today?
Member
Join Date: Oct 2012
Location: Poconos, PA
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0 I6
Found a new gremlin when driving to work tonight. Jeep stalled out and engine shut off when making a right hand turn into the lot. Has half a tank of fuel. So now the Internet troubleshooting begins. It has run fine for the past week no issues. So based on reading, it could be the steering column, a bad ground, fuel pump, fuel filter, PCM issue or crank shaft sensor issue. FML.
CF Veteran
Switched out my old 07' kenwood 316s headunit for a new kenwood 155u, defiantly made a difference and finally got my antenna back from having to use a transmitter for my ipod
The welds are good, I know they will hold. The only part that worries me is it's a Dana 35 with 245000 miles on it turning 33" tires, used as a daily driver and wheeled every weekend.
Senior Member
Join Date: May 2013
Location: Vancouver
Posts: 541
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998 and 1988
Model: Cherokee
Engine: 4.7
installed wide band O2 sensor and gauge with a feed to the PCM.
Still need some fine tuning in programming it but that's for tomorrow.
http://www.innovatemotorsports.com/products/MTXL.php
Still need some fine tuning in programming it but that's for tomorrow.
http://www.innovatemotorsports.com/products/MTXL.php
Senior Member
Join Date: Apr 2012
Location: Los Banos CA
Posts: 735
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
Started prepping the comanche for the 1000 mile drive to our new home. Moving to Idaho for school. The reason I'm selling my cherokee. Going to swap my good wheels and tires between the two. All my goodies I want to keep off the cherokee is going on the comanche. Even though I should keep the cherokee for during the winter since its a 4wd. I'll most likely finish the 4wd conversion while up in idaho so I can safely travel the snow covered roads till I can afford to buy another cherokee.
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,971
Received 1,559 Likes
on
1,263 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
There really isn't a PCV valve. This is a CCV system and uses a fixed orifice in the rear grommet. Can you post a pic of what yours looks like now?
Junior Member
Join Date: Jun 2012
Location: Springfield Mo
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Junior Member
Join Date: Jun 2012
Location: Springfield Mo
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Herp Derp Jerp
Join Date: Nov 2011
Location: Parham, ON
Posts: 18,251
Likes: 0
Received 13 Likes
on
12 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L OBD-II
Member
My black 95 cherokee sport just turned 500k miles today and still running strong woot!
Need to do bearings all around their humming like crazy.
Need to do bearings all around their humming like crazy.
CF Veteran
Join Date: Aug 2012
Location: Bentonville, AR
Posts: 1,281
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1990
Model: Cherokee
Engine: I6 4.0
Herp Derp Jerp
Join Date: Nov 2011
Location: Parham, ON
Posts: 18,251
Likes: 0
Received 13 Likes
on
12 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L OBD-II
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,971
Received 1,559 Likes
on
1,263 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0