Rattle canned rear door, took off rockerpanel trim and found some rust from water staying behind, so i cleared rust and herculined.

 

Finally put the seat back in tested the snorkel and some other odds and ends.....

 

put a bored throttle body on. i like it alot.

 

replaced my motor mounts..... I did not have the oil filter on tight enough... and lost so much oil.

 

adjusted my 4x4 shifter
replaced fan clutch

tomorrow gonna do the thermostat and maybe the water pump. we'll see how the funds are looking.

 

Did a little painting...

 

didn't use my ac at all last year, and not yet this year, so i got the refridgerant evacuated at a garage and started my ac-OBA install. I have it functioning enough to fill tires. Now trying to source a cheap lubricator, oil/water seperator, and a small tank

 

got new fluids for everything
front and rear diff and tcase
got a full tank of gas
next is the fuel filter and a fuel system cleaning
already washed it too
tomorrow goin to the local jy looking for skids and maybe anything else i dont know i want yet

 

removed hitch, only snapped 2 of the 4 bolts, lol. Removed rear bumper, all bolts intact. Now just have to wait till saturday to take it to my parent's house so I can wire wheel and repaint the rear unibody before putting the new bumper and tire holder on.

 

nothing but it did watch me work on my buddies 1988 300zx

 

Washed it and put my Swwampers on for the weekend.

 

Installed 2 new teflon lined braided steel fuel lines, new fuel pump, Fuel Composition Sensor (for running E85), new fuel filter, finished wiring the gauges and indicators.

Gauges are now 100% operational.
At night this....

Looks like this...

 

I replaced the rear drum shoes on both sides and put a new set of swamper TSL radials on

 

Began painting my trimming/cladding last night. Would have probably finished all of it today, but I started my new job. Going to switch out of my dress clothes from work and go paint myself black for a few hours while I work on it some more

 

Rewired my stereo ran my own heavier gauge wire for. Ignition, Constant, and Ground. through the dash and through the grommet. I pulled the one next to the hood latch cable, but now the damn thing won't go back in any ideas? And found my speaker down inside the hatch go figure. Also found a bunch of burnt out light bulbs that need replaced