What did you do to your Cherokee today?
Senior Member
If I had a short piece of hose that would have worked too, but at 10pm on a Friday evening I had to make due with what I had.
Senior Member
Join Date: May 2014
Location: Iroquois Ontario Canada
Posts: 946
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
Member
Join Date: Apr 2015
Location: Morenci, AZ
Posts: 107
Likes: 0
Received 1 Like
on
1 Post
Year: 2000
Model: Cherokee
Engine: 4.0
Added a mod that gave me 115 HP, 390 ft/lbs of torque, traction equivalent to a D11R dozer, and made me irresistible to the opposite sex:
Then I took a cruise and it insisted on a brief sojourn onto the old rail bed:
Then I took a cruise and it insisted on a brief sojourn onto the old rail bed:
Seasoned Member
Join Date: Oct 2011
Location: Out West
Posts: 486
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: I6
Installed my 2" budget boost. I dig it.. slight vibes from 35 - 40 now and a small bit on take off. Saving up for a sye but for now I'm going to do a tcase drop to bandaid it till then
Senior Member
Little TLC for the '99. Greased up the front end joints and the rear shackle bushings, than a drain and refill on the AW4.
CF Veteran
Join Date: Sep 2012
Location: In a large sandbox
Posts: 1,623
Likes: 0
Received 12 Likes
on
12 Posts
Year: 1998
Engine: 4.0
Finished RE6025 3.5" Super-ride kit install on my '98. Used Bilsteins again and had to install an adjustable trackbar.
Since this is a pavement queen, I chose the Teraflex atb.
Drove it briefly to check it out. Rides very well. Will have a better formed opinion after the wheel hub bearings, ball joints and front wheel u- joints are installed this coming week and I get the alignment done.
I will say this: the rear netted about 5.5 inches. I currently have 480 pounds of concrete mix sitting in the rear and it's still off by about 1" from sitting level. May change shackles since they're not OEM length. Have some research to do first.
Since this is a pavement queen, I chose the Teraflex atb.
Drove it briefly to check it out. Rides very well. Will have a better formed opinion after the wheel hub bearings, ball joints and front wheel u- joints are installed this coming week and I get the alignment done.
I will say this: the rear netted about 5.5 inches. I currently have 480 pounds of concrete mix sitting in the rear and it's still off by about 1" from sitting level. May change shackles since they're not OEM length. Have some research to do first.
Seasoned Member
Join Date: Oct 2013
Location: Long Island, NY
Posts: 356
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1999 Limited
Model: Cherokee (XJ)
Engine: 4.0L I6 Power Tech
We took her to the beach (Sore Thumb) for the first time. I hate to admit it but I was not happy with the way she performed. It wasn't even close to over-loaded and still bottomed out front and rear a few times. My stock rear leafs with 2" BDS AAL's are getting swapped out immediately for OME 3" leafs. The pic shows her low in the rear but on pavement she sits level.
Senior Member
Join Date: Aug 2012
Location: Sparks, Nv
Posts: 533
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0 I6
Drove it to pick n pull and got rear ZJ backing plates for my disc brake conversion and brake calipers to use as cores oh and a prop valve everything was half off, good day