When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
looked at it and thought my hard brake line was leaking under the driver side door, until I opened the door and seen the floor was wet with the same oily stuff. tracing it to the back seat and an engine oil bottle on its side leaking. so it ran to the front and leaked thru the herculiner, pinhole I guess. right where I found an almost thru rust hole that's been herculined over, from previous owner. its right behind the drain hole.
I got my Xj, Eugene yesterday
I cleaned his interior then drove it to Rathdrum ID and back to Spokane without a hiccup
Then today tore apart the header panel (Is that what you call the thing that the headlights and grill hook to)
removed the damaged parts and got the headlight adjusters ordered
I also washed and waxed the whole jeep, it made all the difference cause it looks like a different jeep
I dont think the P.O.s even cleaned it once since 94
I got my Xj, Eugene yesterday
I cleaned his interior then drove it to Rathdrum ID and back to Spokane without a hiccup
Then today tore apart the header panel (Is that what you call the thing that the headlights and grill hook to)
removed the damaged parts and got the headlight adjusters ordered
I also washed and waxed the whole jeep, it made all the difference cause it looks like a different jeep
I dont think the P.O.s even cleaned it once since 94
Drove it to work. Drives great! Note to self : check weather before driving to work with no doors. 65% chance of storms and I have an hour ride home..... fun
Spent the morning in 2 boneyards. The first one pulling a computer and a harness I wanted and in the second one prepping the Jeep for removing all the factory privacy glass that I want.
Trimmed the metal and plastic flare hoping I wouldn't have to bumpstop anymore than I already have. Still a little contact with the fender. I guess I'll have to decide what I want to do about more bumpstop. Anyone running progressive bumpstops? finished product of trim. Hits at the very front corner of the fender flare.
Rubbing at full lock. Need to cut the front fender more but not sure if I can cut past the first torx-bolt at the bottom rear of the front fenders. Maybe drill out another hole a bit further back and use a simple bolt + nut to secure the fender? ;
I basically need to cut just aft of the first nut in this picture to clear the 35's at full steering lock.
Or is it just that my front axle is not as far forward as it needs to be, since I only have a short-arm 4.5" lift currently (might got up to a 6.5" lift, but I honestly like the rig being lower COG)