mrfajita

Disconnected the PCV line from the airbox and put a separete filter on it, so it stops dumping black crap into my throttle body.

wildspear

Installed all 3 u-joints in my front drive shaft. One of the u-joints that I took out, when I took the cap off all the needle bearings were gone. Now on tomorrows to do list is changing the u-joints in the axel......alot of play I'll be surprised if any of the needle bearings are there,

OOdynamite

Fixed the problem with my windows. got some rims and brand knew tires from a friend for free, but alas, the bolt pattern was off by a half inch.

peep

Checked all fluids, full
Sprayed some armor all on the squeeky serpentine fan belt.
Cranked the tunes and went to town

TucsonXJ

Welp... I took my xj up redington pass and did some target shooting.

sycoglitch

Changed my air filter today. every since i moved i need to change it every few months now. Bout to put a new check pin in

jayman089

Tried to figure out where my p0456 small evap leak is. Cleared the code after inspecting and tightening the gas cap. I guess if it comes back I'll replace it, clear it again, and see if the code comes back again.

MadMike

This morning I let one of our friendly Ga state troopers search it... Pulled me over for a head light being out. Pulled over 2 times in 24hour for the same problem. Definitely stopping at autozone on the way home to pick up a set of dang headlights. I've been pulled over in my Jeep more times than I was ever pulled over in my lowered and turboed Honda CRX.

jrhockey03

Rebuilt the leaf pack with some Dakota springs, new rear brake shoes, Nighthawk bulbs, fix the contacts on the brake light switch and readjusted the headlights from the extra lift in the rear. From the ground to the bottom of the fender was 36.5" in the front and the rear was 33" in the rear, after we installed the bastard pack it was the same in the front but the rear was up to 36". It rides much nicer now.

Spunkmeyer

I had my muffler heat shield come off and start rattling against the muffler and driveshaft, so I removed it, and removed the small metal nuts that originally held it in place. 4 of the 5 came off with no problem, but the 5th was installed at an angle and was almost impossible to remove. I eventually had to cut it in half and wrench the hell out of it to get it off.

rustcollector

Wired up my 6 roof rack mounted spotlights. Wired my rear facing reversing spotlights. Nearly finished the nudge bar mounted spots but ran out of time.
Will finish them one evening this week.
Then to mount and wire my amber led strobe recovery lights on the roof rack.
Will post some pics of my Jeep soon.

stuck like chuck

finally got the bolt off my stock shackle thanks to the help of a saw zaw. 2 inch lift is completely installed with new shocks. oil pan has tiny leak but i can live with it. ready for trucks gone wild

LittleXJ

walked out side this moring thinken i gana swap lifts walked in the house 10hrs later saying f the coil springs who the f made this up and f the preav owner for leaven the f en controle arms to rust...

going to drop the a frame ( i think that is what its called) and see if i can slide them in i haven sooo much trouble with the lift swap....but hey i wont stop till she is done

crazydays

New stereo is in and Sirius is working again. New speakers to be installed later in the week.

OHHNOES

Took it to the trails on the Mt. broke a motor mount...Came home