Wire routing for light bar drivers side.
#1
Thread Starter
Seasoned Member
Joined: Feb 2021
Posts: 332
Likes: 72
From: Nashville
Year: 2001
Model: Cherokee (XJ)
Engine: 4.0
Wire routing for light bar drivers side.
Just sharing this here because I struggled finding a good way to get wire from the engine bay to my roof via the drivers side. There are no large holes in the side panel like there is on the passenger side by the battery.
toward the back of the engine bay on the drivers side there is a fair size gap that leads into the side panel and comes out at the door. This is exactly where I needed it to tuck behind the door trim and go to the roof.
at first it looks like the pinch seam on the hood will slice it, but it follows the same profile as the gap. I put some thick tape on just incase though.
toward the back of the engine bay on the drivers side there is a fair size gap that leads into the side panel and comes out at the door. This is exactly where I needed it to tuck behind the door trim and go to the roof.
at first it looks like the pinch seam on the hood will slice it, but it follows the same profile as the gap. I put some thick tape on just incase though.
Thread
Thread Starter
Forum
Replies
Last Post
Tracey
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
10-13-2019 05:33 PM
VoluntaryXJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
04-01-2019 06:47 AM
xjohnmatrix
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
01-06-2018 09:37 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)